Table of Contents
Advertisement
6.9 Output settings
You may have already taken a look at the output parameters screen accessible from routing
and settings window, if you haven't please do so now.
As you can see above, all important settings to make sure your speakers stay intact and
sound their best are here: Gains, delays, phase inverts and limiters.
The limiters come with reduction indicators and the current level of each channel is also
visible. Each channel also features an output mute, click the speaker-icon beside the
channels label to (de)activate them. Note that the attack time for the limiter is set as a
function of its release time.
All output parameters can be copied and pasted to any of the other outputs in the same way
as the Crossover and EQ parameters. Place the cursor over the label at the top of the
channel you wish to copy, right click and select Copy. Move to the output channel to which
you would like to paste the settings and again right click on the label and select Paste.
In addition it is possible to copy and paste all output parameters; crossover, EQ, gain, delay
and limiter simultaneously. Hold the Control button down before right clicking over the label
of the output channel to be copied and select Copy Channel. Keep the Control button down
and right click over the label of the channel to which you would like the parameters pasted
and select Paste Channel.
All material © 2007. Martin Audio Ltd. Subject to change without notice.
17
Advertisement
Table of Contents
