Table of Contents
Advertisement
Advertisement
Chapters
Table of Contents
Related Manuals for Ametek Jofra ETC-400 A
Summarization of Contents
Introduction to AMETEK Jofra Calibrators
Warranty Information
Details the instrument's warranty coverage and limitations for defects.
Safety Instructions and Warnings
WEEE Directive Disposal
Guidance on proper recycling and disposal of electrical and electronic circuits.
General Safety Warnings
Mandatory instructions to avoid personal injury and instrument damage.
Hot Surface Caution
Warning about touching hot parts of the calibrator to prevent burns.
Cold Surface Caution
Warning about touching cold parts, especially on ETC-125 A models, to prevent frostbite.
Setting Up the Jofra Temperature Calibrator
Receiving and Unpacking the Calibrator
Instructions for checking and unpacking the calibrator and accessories upon receipt.
Preparing the Calibrator for Use
Essential preparation steps including power connection, environment, and safety.
Insertion Tube and Well Selection
Guidance on selecting the correct insertion tube and bore for calibration.
Inserting the Sensor
Procedure for safely inserting the sensor into the calibrator's well.
Operating the Jofra Temperature Calibrator
Keyboard, Display, and Connections Overview
Description of the instrument's keyboard layout, display segments, and external connections.
Starting the Calibrator
Steps to power on the instrument and initiate the startup sequence.
Setting the Target Temperature
Procedure for setting the desired temperature for calibration.
Using the Automatic Stepping Function
How to configure and use the AUTO STEP function for sequential temperature changes.
Navigating the MENU System
Overview of the MENU structure for accessing settings and parameters.
Adjusting Temperature Units (°C/°F)
Procedure to select between Celsius and Fahrenheit for temperature display.
Adjusting Maximum Temperature Limit
Setting the upper limit for the calibrator's operational temperature.
Setting Extra Stability Time
Configuring the additional time required after stability for signal confirmation.
Adjusting Temperature Resolution
Setting the display resolution for temperature readings (e.g., number of decimals).
Calibrating IR-Thermometers (ETC-400 R)
Specific procedure for calibrating infrared thermometers using the ETC-400 R.
Simulation and Training Mode
How to activate and use the simulation mode for personnel training.
Storing and Transporting the Calibrator
Storage and Transport Precautions
Guidelines to ensure the instrument and sensor remain in good working order during storage.
Hot Surface Warning During Storage/Transport
Safety warning regarding hot surfaces when handling the calibrator after use.
Error Codes and Troubleshooting
Service and Repair Warnings
Important warnings regarding servicing, user-serviceable parts, and liability.
Troubleshooting Error Codes
Explanation of common error codes, their likely causes, and solutions.
Maintenance and Calibration Procedures
Cleaning and Care Procedures
Instructions for cleaning the instrument's exterior, keyboard, insertion tube, and well.
Instrument Adjustment and Calibration
Guidance on performing self-calibration or using accredited services.
Adjusting Calibration Date
Procedure to set or update the calibration date on the instrument.
Performing Internal Calibration/Adjustment
Detailed steps for the internal calibration and adjustment process.
Calibrating/Adjusting the ETC-400 R
Specific instructions for calibrating the ETC-400 R model's internal thermometer.
Technical Specifications
Thermal Specifications
Performance details and operating ranges related to temperature.
Electrical Specifications
Details on power supply requirements and consumption.
Mechanical Specifications
Physical dimensions, weight, operating, and storage conditions.
Observed Standards and Directives
Compliance with EMC and Low Voltage directives and relevant standards.
Need help?
Do you have a question about the Jofra ETC-400 A and is the answer not in the manual?
Questions and answers