Arcam AVR400 Handbook page 13

Component/RGb video
connectors
These inputs are suitable for connection to source
devices which output Component (YUV or YPbPr) or
rgB high quality analogue video signals. These signals
are usually available from BD players, set-top boxes or
games consoles.
If you are connecting up to an rgB source you may also
need to connect the source's Composite output to the
AVr400 Composite input to act as a video sync ('rgB
+ Sync' format). The Composite signal should be on the
same named input as the rgB signals. The AVr400 is
also compatible with 'Sync on green' or 'rgsB' signals.
rgB video outputs on source equipment are often on
SCArT connectors. You will need to use a SCArT to
'rgB+Sync on phono' breakout cable, available from
your Arcam dealer.
NOTE
When setting up the AVr400 menus (later in
this manual), you will need to select whether the
three-wire high quality video input is Component
('normal'), 'rgsB' or 'rgB + Sync' for each input.
This is done on the 'Component Mode' line in the
Input Config menu. Failure to do this can result in a
green looking picture or a picture that is unstable.
COMPONENT VIDEO IN SAT, AV, BD
Connect the Component video outputs of your source
equipment to these inputs.
COMPONENT VIDEO OUT
Connect this output to the Component video input of
your display device.
NOTE
Analogue rgB video output is not available from
the AVr400. The analogue three-wire high quality
video output is always configured as Component
video.
Zone 2 connectors
The Z2 out analogue audio connector can be used
to connect the stereo audio output of the AVr400
to an amplifier located in a second room. Connect
the analogue video output to your Zone 2 display
equipment. See 'Multi-room Setup' on E-46 for
information.
S-Video and Composite
connectors
AV, VCR, BD, SAT
Connect these inputs to the S-Video and Composite
outputs of your available source equipment.
E-11
digital audio connectors
VCR, PVR, BD, CD, AV, SAT
Connect these inputs to the digital outputs of your
available source equipment.