Remote - Velodyne SMS-1 - OUTLAW GUIDE Manual

THE OUTLAW'S GUIDE TO THE SMS-1
RP10 Thru Audio Output
This output provides an unaltered copy of the input received by
the SMS-1. If you have several SMS-1 units in your equipment
rack, you can daisy-chain them together by connecting the Thru
output of the first unit to the LfE input of the second unit.
RP11 Audio Output
This stereo analog audio output includes an 80Hz high-pass
cross-over. If your processor has no LfE output, you can connect
your left and right pre-amp outputs to the audio inputs (rp1)
and connect these outputs to the amplifier that powers your left
and right speakers.
RP12 Audio Input (LFE)
This stereo analog audio input is mainly intended for connecting
the LfE output from your receiver or processor to the SMS-1;
either the left or right input can be used. This input can also be
used along with the left and right pre-amp outputs if no sub-
woofer/LfE output is available.
RP13 12V Trigger
A 1V trigger (such as the triggers often found on receivers or sur-
round processors) can be connected here to turn the SMS-1 on
whenever a 1V signal is present. The trigger must be enabled in
the SMS-1's menu. We'll show you where later (see page 0).
RP14 Speaker Level Audio Input
Exposed (bare) speaker wire can be connected here. This is use-
ful for systems in which no subwoofer/LfE output is available at
the receiver.
RP15 12V DC Power Input
connect the included power supply to the SMS-1 here.
rEMOTE cOnTrOL
The SMS-1's remote control is pretty straightforward. We've all probably
used power buttons, number pads, volume controls, and navigation pads
before, but here's the full run-down anyway.
Power
Toggle unit between Standby and On. you'll need to press the power
switch on the front panel once to turn the unit's master power on first.
Number Pad
Use to enter codes to activate different modes such as the main menu,
auto-Eq, and system reset.
Mute
Mute and un-mute the unit. Think of this as a mute just for your
subwoofer.
Set (+/-)
Set values in the System Settings menu or adjust the q value for a select-
ed equalizer band.
Light
Toggle the front panel display light on and off.
7