Anti-Theft-Code Function; Rear Zone; System Reset; Mute - ZENEC ZE-MC192 Instruction Manual

ANTI-THEFT-CODE FUNCTION

■ The anti-theft-code setup item exist in the
second page of the general setup menu.
Settings Default
Anti-theft-code 0000
Anti-theft Off

REAR ZONE

■ If a monitor is installed in the rear zone and connected to the rear zone AV output,
passengers on the back seat can control the unit by using the rear zone remote
control.
■ See "Multi-Zone Remote Control" for instructions.

SYSTEM RESET

■ To correct a system halt or other unusual operation, use the tip of a pen to press the
[RESET] button which is located on the front bottom-right corner of the unit. After a
system reset, the unit restores the settings before the last power off.

MUTE

The volume will be muted when the following cases occur:
■ Automatic: Audio output mutes, when a telephone call is received by the car phone or
when verbal navigation is performed.
■ When the "MUTE" wire is connected to a cell phone that will output a mute signal to the
"MUTE" wire.
■ Manual: Press the [MUTE] button on the front panel or the [MUTE] button [
remote control to mute the volume.

NOTE:
■ Press the [MUTE] button again to restore the volume.
■ Adjusting the volume or using any of the audio setup features will cancel the mute
function.
Options Functions
---- You have to enter the password to turn
anti-theft on or off.
On System will require a password, if main
battery power is remove for more than 40
seconds.
Off No password is required, if main battery
power is remove.
88
RESET-Taste
] on the