Denon AVR-2805 Operating Instructions Manual page 46

ENGLISH
• Operating the surround mode and surround parameters from the main unit's panel.
1
Turn the SELECT knob to select the surround
mode.
SELECT
(Main unit) (Main unit)
• When turned clockwise
DIRECT STEREO DOLBY PRO LOGIC
VIRTUAL MATRIX VIDEO GAME
• When turned counterclockwise
DIRECT STEREO DOLBY PRO LOGIC
VIRTUAL MATRIX VIDEO GAME
To select the surround mode while adjusting the surround parameters or tone control, press the
surround mode button then operate the selector.
2
Press the SURROUND PARAMETER button.
Press and hold in the surround parameter
button to select the parameter you want to set.
• The parameters which can be set differ for
the different surround modes. (Refer to
"Surround Modes and Parameters" on page
47.
(Main unit)
Room EQ / Tone control setting
• Use the Room EQ setting and the tone control setting to adjust the bass and treble as desired.
• Operate the Room EQ and the tone control from the remote control unit.
1
Press the surround parameter button.
Display the surround parameter screen.
The screen selected surround mode
appears.
"TONE" cannot be selected in the Direct
mode.
(Remote control unit)
46
1
II x DTS NEO:6 5/7CH STEREO WIDE SCREEN SUPER STADIUM
MONO MOVIE CLASSIC CONCERT JAZZ CLUB ROCK ARENA
II
x DTS NEO:6 5/7CH STEREO WIDE SCREEN SUPER STADIUM
MONO MOVIE CLASSIC CONCERT JAZZ CLUB ROCK ARENA
3
Display the parameter you want to adjust, then
turn the SELECT knob to set it.
NOTE:
• When playing PCM digital signals or analog
signals in the DOLBY PRO LOGIC II, DTS NEO:6
modes and the input signal switches to a digital
signal encoded in Dolby Digital, the Dolby
surround mode switches automatically. When
the input signal switches to a DTS signal, the
mode automatically switches to DTS surround.
2
Select
"EQ/TONE".
(Remote control unit)
2 1, 3
3
Display the Room EQ / Tone Control screen.
(Remote control unit)
4
Select the Equalizer setting.
(Remote control unit)
OFF Normal Front
Manual Flat
NOTES:
• The equalizer setting of Normal, Flat, and Front can be selected after performing the Auto Setup.
• When headphone is connected, the Room EQ cannot be used.
• Operate the Room EQ from the main unit.
1, 8
2 ~ 6
7
1
Press
PARAMETER button.
• Display
parameter screen.
(Main unit)
5
(Remote control unit)
6
Select Bass or Treble.
(Remote control unit)
7
(Remote control unit)
8
(Remote control unit)
2
Select "EQ".
(Main unit)
1, 2 3
3 Select the Equlizer setting.
the SURROUND
SELECT
the surround
(Main unit)
Select Tone Defeat OFF.
Set the level.
(Remote control unit)
Enter the setting.
The surround parameter
menu screen reappears.
If the setting ends, press the
"ENTER" or "SURROUND
PARAMETER" button again.