Denon AVR-2805 Operating Instructions Manual page 15

Check of the measurement results
1
Select the items.
The measurement results of each item can be checked
here.
(Remote control unit)
2
Press the ENTER button and display the verification
screen.
(Remote control unit)
NOTE:
• When measurements have been made using the measurement microphone,
speakers with a built-in filter such as subwoofers might be set with a value that
differs from the physical distance because of the internal electrical delay.
[Speaker Config. Check]
3
If the check ends, press the ENTER button again.
(Remote control unit)
4
Select from the following three items based on the
measurement results.
• Store : Set with the checked measurement value.
• Retry : Perform the measurement again.
• Cancel : Cancel the checked measurement value.
(Remote control unit)
5
When the "Store" is selected, all parameters are stored
up.
When the "Retry" is selected, it measures again.
(Remote control unit)
[Delay Time Check] [Channel Level Check]
1-2 Setting the Manual EQ Setup
Adjust the tone of the various speakers except subwoofer while listening to the sound (music).
1
Select "Manual EQ Setup" at the Auto Setup / Room
EQ Menu.
(Remote control unit)
2
Display the Manual EQ Setup screen.
(Remote control unit)
3
Select the speaker to be set.
The display changes as follows.
FL
(Remote control unit) SBR
When the surround back speaker setting is set to
"1spkr" at "Speaker Configuration", this is set to
"SB".
4
Select the frequency.
(Remote control unit)
5
Use the cursor left and right buttons to adjust the Gain
level.
• Each frequency can be adjusted the range from –6 dB
to +6 dB in 0.5 dB step.
(Remote control unit)
6
Enter the setting.
The Auto Setup / Room EQ Menu reappears.
(Remote control unit)
FR C SL
SBL SR
SB
Flashing
1spkr
ENGLISH
15