Denon AVR-2805 Operating Instructions Manual page 40

ENGLISH
Fader function
• This function makes it possible to lower the volume of the front channels (FL, C and FR) or the rear channels
(SL, SR, SBL and SBR) together. Use it for example to adjust the balance of the sound from each position
when multi-channel music sources are played.
1
Select "FADER".
The channel switches in the
order shown below each
time this button is pressed.
(Remote control unit)
FL C FR SR SBR
SW SL
FADER
2
Press the CURSOR
button to reduce the volume
of the front channels, the
CURSOR right button to
reduce the volume of the rear
(Remote control unit) channels.
The fader function does not affect the SW
channel.
The channel whose channel level is adjusted
lowest can be faded to –12 dB using the fader
function.
If the channel levels are adjusted separately after
adjusting the fader, the fader adjustment values
are cleared, so adjust the fader again.
II
Dolby Pro Logic x (Pro Logic
To play in the PL IIx mode, set "Sp.Back" at the Speaker Configuration setting to "1Spkr" or "2Spkrs".
To play in the PL IIx mode, set "Surround Back" at the Power Amp Assign setting.
1
3, 5 1, 4, 6
1
Select the Dolby Pro Logic IIx mode.
SELECT
(Main unit) (Main unit) (Remote control unit)
40
2
SBL
1
left
This is only displayed when setting the fader control.
II
) mode
The Dolby Surround
Pro Logic IIx Cinema
or Music mode can be
chosen directly by
pressing the CINEMA
1
or MUSIC button on
the remote control
unit during playback in
the Dolby Pro Logic
IIx mode.
5
3, 7
4, 6 4, 6
7
5
2
Play a program source with the
• For operating instructions, refer to the manuals of the respective components.
3
Set the surround parameter mode.
(Main unit)
2
4 Select the play mode.
SELECT
(Main unit)
• When the "SB CH OUT" parameter is set to "ON".
(Set "SP.Back" at the system set up to "1spkr" or "2spkrs").
Display
(Pro LogicIIx Cinema mode)
• When the "SB CH OUT" parameter is set to "OFF".
(Set "SP.Back" at the system set up to "None").
Display
(Pro LogicII Cinema mode)
5 Select the parameter to change. (See "Surround parameters q" for a description of each parameter.)
(Main unit)
When set with the on-screen display using the remote control unit while in the MUSIC mode, set the
" " mark to "OPTION 0" using the CURSOR up and down buttons, then press the CURSOR left
button.
Press the ENTER button to return to the previous screen.
mark.
(Remote control unit)
The on-screen display differs according to whether the
operation is performed from the main unit or the
remote control unit.
NOTE:
• The PLIIx mode is set when the "SB CH OUT"
surround parameter is set to "ON", and the PLII
mode is set when this parameter is set to "OFF".
(Remote control unit)
(Pro LogicIIx Music mode) (Pro LogicIIx Game mode)
(Pro LogicII Game mode)
(Pro LogicII Music mode)
Ex : DOLBY PLIIx music mode screen.
(Remote control unit)
(Dolby Pro Logic mode)