Denon AVR-2805 Operating Instructions Manual page 12

ENGLISH
4. Advanced Playback
Advanced Playback
Set the audio delay to delay time the sound and
1
Audio Delay
synchronize it with the picture.
Dolby Digital Turn the audio compression on or off when down-
2
Setup mixing Dolby Digital signals.
Auto
3
Surround Set the Auto surround mode function.
Mode
5. Option Setup
Option Setup
Power AMP Set this to switch the surround back channel's
1
Assignment power amplifier for use for zone2.
This sets the output level the zone2 output jacks.
Zone2 vol.
2
This menu is not displayed, when "ZONE2" is
Level
selected at Option Setup "Power Amp Assign".
Trigger Out1 Set the Trigger Out1 output for the each input
3
Setup sources.
Trigger Out2 Set the Trigger Out2 output for the each input
4
Setup sources.
This sets the amount of attenuation at audio
5
Muting Level
output muting.
This sets whether or not to display the on-screen
display that appears on the monitor screen when
On Screen
6
the controls on the remote control unit or main unit
Display
are operated.
A setting to prevent flickering.
Set whether or not to lock the system setup
7
Setup Lock
settings so that they cannot be changed.
NOTES:
• The on-screen display signals are output with priority to the S-VIDEO MONITOR OUT jack during playback
of a video component. For example, if the TV monitor is connected to both the AVR-2805's S-Video and
video monitor output jacks and signals are input to the AVR-2805 from a video source (VDP, etc.) connected
to both the S-Video and video input jacks, the on-screen display signals are output with priority to the S-
Video monitor output. If you wish to output the signals to the video monitor output jack, do not connect a
cord to the S-VIDEO MONITOR OUT jack. (For details, see page 28.)
• The AVR-2805's on-screen display function is designed for use with high resolution monitor TVs, so it may
be difficult to read small characters on TVs with small screens or low resolutions.
• The setup menu is not displayed when headphone are being used.
12
Default settings
0 ms
OFF
Auto Surround Mode = ON
Default settings
Surround Back
Variable
ZONE=MAIN
CDR/
CD TUNER DVD VDP TV DBS VCR-1 VCR-2
PHONO
TAPE
OFF OFF OFF OFF ON ON ON ON ON ON
ZONE=2
CDR/
PHONO CD TUNER DVD VDP TV DBS VCR-1 VCR-2
TAPE
ON ON ON ON ON ON ON ON ON ON
---dB (minimum)
On Screen Display = ON / Mode 1
Setup Lock = OFF
• Speaker system layout
Basic system layout
• The following is an example of the basic layout for a system consisting of eight speaker systems and a
television monitor:
Subwoofer
Front speaker systems
Set these at the sides of the TV or
V. AUX
screen with their front surfaces as flush
with the front of the screen as possible.
ON
V. AUX
ON
Center speaker system
Surround back speaker systems
Surround speaker systems