Advertisement
Advertisement
Table of Contents
Related Manuals for COMENDA LC380
Summary of Contents for COMENDA LC380
- Page 1 Instruction manual for dishwashers LP360 LP360A LC380 LC380A...
- Page 2 FOREWORD 1. Read the instructions contained in the enclosed booklet carefully, because it contains important information on installation, operation and maintenance safety. Store this booklet carefully for any further consultation by other operators. 2. Having removed the packing material, check that all the equipment is present.
- Page 3 INSTRUCTIONS FOR USE...
-
Page 4: Operation And Use
INSTRUCTIONS FOR THE USER OPERATION AND USE 1)Before washing make sure that: • the wall-mounted on/off switch is switched on; • the water tap is open; • water is present in the distribution network; • the pump protection filters are installed in their respective positions; •... - Page 5 INSTRUCTIONS FOR THE USER 6)To start the wash cycle simply close the side doors or hood, the end of which will be indicated by the switching off of the "D” lamp. N.B.: Machine in conformity with the existing hygienic standards, guaranteeing a final rinse at 82°C.
-
Page 6: Useful Suggestions
INSTRUCTIONS FOR THE USER USEFUL SUGGESTIONS 1) MAINTENANCE IMPORTANT: Before carrying out the cleaning and maintenance operations, disconnect the equipment from the electric supply. Frequently check and clean the nozzles. The frequency of this operation will depend on the quantity of residues, which may result in an unsatisfactory washing result. -
Page 7: Hard Water Conditions
INSTRUCTIONS FOR THE USER 5)HARD WATER CONDITIONS If a hard water supply is present, mineral deposits will form within the machine and also on dishware. In order to avoid the above conditions a periodic removal of these deposits is necessary. The frequency and method of this operation upon consultation by your detergent supplier. - Page 8 INSTALLATION AND MAINTENANCE INSTRUCTIONS The following instructions are addressed to a qualified personnel the only one authorised to carry out checks and repairs, if any. The manufacturer declines any responsibility in the case of interventions made by a non qualified personnel or the use of spare parts other than those supplied by the Manufacture.
-
Page 9: Installation
Supply 380V 3N Supply 220V/3 Supply 220V/1 LP360 LC380 For other supplies the cable cross section and the circuit breaker switch must be calculated according to voltage and length of cabling. If cabling too long adjust cable size to Amp rating; do not pull on supply cable or install it under... -
Page 10: Water Connection
INSTRUCTIONS FOR TECHNICAL PERSONNEL 2)WATER CONNECTION Install a 55°C water tap in a well accessible place, terminating in a 3/4" fitting, which the pipe strainer and inlet hose shall be connected to. Carefully comply with any national or regional regulations in force. The operating pressure should be neither less than 2 bars or greater that 4 bars (200/400 kPa). -
Page 11: Energy Consumption
55°C inlet hour with water 12°C inlet water LP360 3000 4200 4800 40/30/20 LC380 3000 6000 1500 10500 48/30/20 In the event of low water supply temperature, there will be a subsequent... -
Page 12: Wiring Diagram
INSTRUCTIONS FOR TECHNICAL PERSONNEL WIRING DIAGRAM Main switch Drain switch (if required) Pilot lamp power on Pilot lamp machine ready Pilot lamp machine working Pilot lamp drain cycle (if required) Wash pump contactor Booster heater contactor C2bis Safety contactor of booster heater Tank heater contactor Relay Wash timer... - Page 13 INSTRUCTIONS FOR TECHNICAL PERSONNEL REFER TO ELECTRICAL DRAWING...
Need help?
Do you have a question about the LC380 and is the answer not in the manual?
Questions and answers