Thermo Scientific ALPHA PH 560 Manual page 39

34
to their default values.
Select operation mode: The upper display shows the last
4
configured operation mode. ('ASY' or 'SY').
Press ▲ or ▼ key to select your desired operational mode.
Press ENT key to confirm your selection.
Reset to factory defaults: The display shows 'nO dEF'.
5 5
Press ▲ or ▼ key to select:
nO Not default reset of the pH Controller. User configured
dEF: values remain active, when confirmed by pressing ENT
key.
FCt Reset all settings of the pH Controller to factory
dEF: defaults, when confirmed by pressing ENT key.
CAL Reset all calibration settings of the pH Controller to
dEF: factory defaults, when confirmed by pressing ENT key.
Press ENT key to confirm your selection.
If 'nO dEF' was selected, the pH Controller reverts to Cnfg
screen. Press ▲ or ▼ key to access other setup screens or
Press ▲ and ▼ key simultaneously (escape) to return to
measurement mode.
If 'FCt dEF' or 'CAL dEF' was selected, the pH Controller
performs the selected reset and returns to measurement mode.
Press ▲ or ▼ key to access other setup screens or Press ▲ and ▼
key simultaneously (escape) to return to measurement mode.
To exit from any intermediate steps, Press ▲ and ▼ keys
simultaneously (escape). The pH Controller returns to the first screen
configuration settings (Cnfg).
Press ▲ or ▼ key to access other setup screens or Press ▲ and ▼
key simultaneously (escape) to return to measurement mode.
To exit from any intermediate steps, Press ▲ and ▼ keys
simultaneously (escape). The pH Controller returns to the first screen
configuration settings (Cnfg).
Thermo Scientific Alpha pH 560