Thermo Scientific ALPHA PH 560 Manual page 33

Relay A/Relay B
28
Press ▲ or ▼ key to access other setup screens or Press ▲ and ▼
key simultaneously (escape) to return to measurement mode.
To exit from any intermediate steps, press ▲ and ▼ keys
simultaneously (escape). The pH Controller returns to the first screen
of temperature settings SET ºCF.
NOTE:
Setting
The SP1 settings determine the operating parameters for Relay A; while
SP2 settings define the operating parameters for Relay B. Since these
two settings have identical setup parameters, only SP1 is described here.
The pH Controller allows you to configure two independent sets of
operating parameters for each relay (Relay A & B) for each
measurement mode (pH & ORP). However, when you switch
measurement modes, the relay operating parameters will be reset
automatically to their default values for that particular measurement
mode.
Figure 5–23. Setting Relays
From pH (or ORP) measurement mode press ENT key to
1 1
enter setup mode as described in page 38 The LCD shows the
first screen of setup mode (OFS). Press ▲ or ▼ key to select
relay A (Set point 1) settings screen (SP1).
Press ENT key to access control relay settings (SP1).
Setting set point value: The upper display shows the last
2
to adjust the upper display to desired calibration
temperature. Allowable range: –10.0 to 125.0°C / 14.0 to
257°F.
Press ENT key to confirm the calibration temperature.
The pH Controller reverts to SET ºCF screen.
If Controller type is set to 'OFF' (Refer page 32 for
Controller settings), the 'Relay A/Relay B Setting' is not
available.
Thermo Scientific Alpha pH 560