Setting The Remote; Learning Function - Denon AV SURROUND RECEIVER AVR-5308CI Owner's Manual

Signal transmission
indicator
[ AMP]
[ TU]
[ NET/DTU]
[SYSTEM CALL]
[CHANNEL+/–]
[NUMBER]

Setting the Remote ID
When using multiple DENON AV receivers in the same room,
make this setting so that only the desired AV receiver operates.
1
[AMP]
[MODE Press
SELECTOR]
AMP mode.
2
Press and hold in
The signal transmission indicator flashes twice.
3
Refer to the table at the right, and use
input the 5-digit number corresponding to the remote
[POWER ON]
ID to be changed.
The signal transmission indicator flashes twice.
4
[TU]
Press ,
be set.
5
Repeat steps 2 to 4 to set the remote IDs for all modes.
[RC SETUP]
MODE
SELECTOR
AMP
(MAIN)
Remote ID
1
81001
(Default)
2 82001
3 83001
4 84001
[8], [9],
NOTE
[1],
• When changing a setting, be sure to set the same remote ID as the
[6], [7],
AVR-5308CI's (vpage 41).
[3], [2] • When changing the AMP mode's remote ID, also change the
"TUNER" , "iPod" and "NET/DTU" remote ID at the same time.
• Set the remote ID of an analog tuner for "TUNER" (
remote ID for "
to set the main remote control unit to the
[RC SETUP]
for at least 3 seconds.
[NUMBER]
[iPod] [NET/DTU]
or to select the mode to
TUNER
NET/DTU
iPod
(Analog (XM)
(Net (HD
TUNER)
Audio) Radio)
52863 52864 72815 62865 62840
52795 52812 72816 62837 62841
52800 52813 72817 62838 62842
52805 52814 72818 62839 62843
), the XM
" .

Learning Function

If your AV devices are of a brand other than DENON or if they
cannot be operated with the preset memory function, their
remote control signals can be transfered to stored in the AVR-
5308CI's main remote control unit.
1
[MODE SELECTOR]
Press for the device you want to
set.
2
[RC SETUP]
Press and hold in
to The signal transmission indicator flashes twice.
3
[9] [7] [5]
Press , and , in that order.
The signal transmission indicator flashes twice and the learning
mode is set.
4
Press the button to be set.
The main remote control unit's display turns off.
b If a button that cannot be learned is pressed, the signal transmission
indicator lights but the signal is not learned.
5
Point the main remote control units directly at each
other and press and hold the button on the other
device's remote control unit that you want to learn.
Once learning is completed normally, the display lights and the
signal transmission indicator flashes twice.
AVR-5308CI's main remote
control unit (RC-1067)
b If you want to learn other buttons, repeat steps 4 and 5.
b The mode can be switched by pressing
b The signal transmission indicator lights once for a long time if
learning was not possible
6
[RC SETUP]
Press and hold in
The signal transmission indicator flashes twice and the setting
is completed.
for at least 3 seconds.
Other device's
remote control unit
[MODE SELECTOR]
.
for at least 3 seconds.