Setting The Remote; Learning Function - Denon AVR-3808CI Owner's Manual

[ AMP]
[ TU]
[ NET/DTU]
[NUMBER]
Setting the Remote ID
When using multiple DENON AV receivers in the same
room, make this setting so that only the desired AV receiver
operates.
1
[AMP]
Press to set the main remote control unit to the
AMP mode.
2
[RC SETUP]
Press and hold in for at least 3 seconds.
The signal transmission indicator flashes twice.
3
Refer to the table at the right, and use
input the 5-digit number corresponding to the remote
ID to be changed.
The signal transmission indicator flashes twice.
4
[TU] [iPod] [NET/DTU]
Press , or to select the mode to
be set.
5
Repeat steps 2 to 4 to set the remote IDs for all
modes.
Signal
MODE
transmission SELECTOR
indicator
[MODE SELECTOR]
Remote ID
[ iPod]
1
(Default)
2
3
4
NOTE
• When changing a setting, be sure to set the same remote ID as the
AVR-3808CI's (vpage 35).
• When changing the AMP mode's remote ID, also change the
"TUNER" , "iPod" and "NET/DTU" remote ID at the same time.
• Set the remote ID of an analog tuner for "TUNER" – "DEVICE1" , the
XM remote ID for "DEVICE2" .

Learning Function

[RC SETUP]
If your AV devices are of a brand other than DENON or if
they cannot be operated with the preset memory function,
their remote control signals can be transfered to stored in
the AVR-3808CI's main remote control unit.
1
[MODE SELECTOR]
Press
set.
2
Press and hold in
The signal transmission indicator flashes twice.
3
[9] [7]
Press ,
The signal transmission indicator flashes twice and the learning
mode is set.
4
Press the button to be set.
[NUMBER]
to
The main remote control unit's display turns off.
b If a button that cannot be learned is pressed, the signal transmission
indicator lights but the signal is not learned.
TUNER NET/DTU
AMP DEVICE1
DEVICE1 DEVICE2 iPod
(MAIN) (Net
(Analog (XM)
Audio /
TUNER)
USB)
81001 52863 52864 72815 62865
82001 52795 52812 72816 62837
83001 52800 52813 72817 62838
84001 52805 52814 72818 62839
for the device you want to
[RC SETUP]
for at least 3 seconds.
[5]
and , in that order.
5
Point the main remote control units directly at each
other and press and hold the button on the other
device's remote control unit that you want to learn.
Once learning is completed normally, the display lights and the
signal transmission indicator flashes twice.
AVR-3808CI's main remote
control unit (RC-1068)
b If you want to learn other buttons, repeat steps 4 and 5.
b The mode can be switched by pressing [MODE SELECTOR].
b The signal transmission indicator lights once for a long time if
learning was not possible
6
[RC SETUP]
Press and hold in for at least 3 seconds.
The signal transmission indicator flashes twice and the setting
is completed.
• With some remote control units, the signals cannot be learned or the
device will not operate properly even when the signals have been
learned. In this case, use the device's own remote control unit.
• Learned buttons have priority over the preset memory. If you no
longer need the learned setting, reset the learning function (vpage
64).
NOTE
• [HOME] cannot be learned.
• Do not learn any remote control signals at [RC SETUP].
• The AMP , ZONE2, ZONE3, ZONE4 and SYSTEM CALL modes cannot
be learned.
Other device's
remote control unit