Setting An On-Delay Time Lag; Setting An Off-Delay Time Lag - EUTECH INSTRUMENTS ALPHA CON 1000 CONDUCTIVITY CONTROLLERTRANSMITTER (REVISION 3) Instruction Manual

Operating Instructions
7.3.5

Setting an on-delay time lag

You can set as time delay for each relay, which stops the relay from switching on the moment the set
point is exceeded. This controller lets you set a 0 to 1999 seconds time delay before the relay
activates.
1) Follow directions in 7.3.1 to enter Control Relay mode.
2) Press the ENTER key. Scroll with the ▲ and ▲ keys until the
upper display shows "0" time and the lower display shows
"On.d".
3) Press the ▲ or ▼ keys to enter on-delay time for Set point 1
(Set point 2). The controller will delay activation for the number
of seconds (0 to 1999) you select.
4) Press the ENTER key to confirm your selection.
5) Proceed to 7.3.6, or return to Measurement mode by pressing the ▲ and ▼ keys
simultaneously (escape).
7.3.6

Setting an off-delay time lag

You can set as time delay for each relay, which stops the relay from switching off the moment the
value reached the set point and hysteresis. This controller lets you set a 0 to 1999 seconds time delay
before your relay deactivates.
1) Follow directions in 7.3.1 to enter Control Relay mode.
2) Press the ENTER key. Scroll with the ▲ or ▼ keys until the
upper display shows "0" time and the lower display shows
"OF.d".
3) Press the ▲ or ▼ keys to enter on-delay time for Set point 1
(Set point 2). Your controller will delay activation for the
number of seconds (0 to 1999) you select.
4) Press the ENTER key to confirm your selection.
5) Continue with Advanced Set-up mode procedures, or return to Measurement mode by pressing
the ▲ and ▼ keys simultaneously (escape).
16
αlpha-CON1000
HOLD SETUP
0
O .
6
HOLD SETUP
0
OF.
6