Overview; Keypad And Display; Keypad; Display - EUTECH INSTRUMENTS ALPHA CON 1000 CONDUCTIVITY CONTROLLERTRANSMITTER (REVISION 3) Instruction Manual

Operating Instructions
4

OVERVIEW

4.1

Keypad and Display

4.1.1

Keypad

•
Perform rapid calibration
•
Allows entry to Set up mode
•
Select individual functions within the function group of Set up mode
•
Store input data in the Set up mode
•
Start calibration in the calibration mode
•
Select various function groups in the Set up mode.
•
Set parameters and numerical values in sub functions of Set up mode
If pressed continuously, the setting speed increases
•
Control the relays in the MANUAL function
•
Return to the Measurement mode when both keys are pressed together
•
Switch between AUTO and MANUAL relay operation using a code
•
Display limit set-point values for the switch contacts in AUTO relay operation mode
•
Switch between RELAY A and RELAY B in MANUAL relay operation mode
4.1.2

Display

The LCD display features two numerical displays that show status messages and measured values for
easy, quick reference. The display provides short-text information for setting parameters and
configuration.
HOLD
SETUP MEAS
READY - 8 . 8 . 8 . 8
- 1 . 8 . 8 . 8
8
•
Display for RELAY A/B. Green LED indicates measured value within limit while
RED LED indicates measured value outside limit.
•
Alarm display if limit value overshoot or the ATC connection is broken.
•
HOLD: Relay position and current output are frozen
•
SETUP: Set-up mode of function groups
CAL
•
MEAS: Measurement mode
mS
µ
S
•
CAL: Calibration mode of Conductivity
•
READY: Comes on after a successful calibration
°C
•
ATC: Comes on in the ATC mode. Disappears in the
Manual temperature Compensation mode. "ATC"
ATC
flashes if the temperature probe is faulty in its ATC
mode
•
8: Indicates the measurement range selected. Refer to
Appendix 2.
5
αlpha-CON1000