HP 175X - JetDirect Print Server User Manual page 118

After about 3 seconds, the power/status LED
button until the power/status LED
b. Briefly press and release the test
in the next language.
c. Verify that a readable page is printed. Repeat these steps up to four times if necessary to
receive a configuration page you can read.
If you still cannot read the page, refer to your printer documentation to find out which of the
following 4 printer languages are supported by your printer:
ASCII
PCL
PostScript
HP/GL-2
5. If you cannot read the language printed on the page and you could read English, French, Italian,
German, or Spanish, you can request the configuration page be printed in those 5 languages:
Press the print server's test
A page for each of the 5 languages will emerge from the printer.
Note: the language printed on the page by default (when you press test
either determined by the control panel settings for the printer, or if that is not supported, English
is used.
6. It may be necessary to re-initialize the connection between the printer and the print server by
cycling power on the print server. (Unplug the power cable from the print server; then plug it
back in.) Do this with the printer switched ON.
Can you now print a readable Jetdirect configuration page?
If yes, click on the Yes button for information on interpreting the configuration page.
If no, your print server has a problem that requires assistance from HP Jetdirect technical support; click
on the No button for information on contacting HP.
is flashing green. Then release the button.
button once again to request the configuration page
button three times and on the third press, hold it for two seconds.
changes to amber. Continue to hold the
once, briefly) is
©2000, 2001 Hewlett-Packard Company