HP 175X - JetDirect Print Server User Manual page 67

1. Open your browser and enter the print server's current IP address as the URL. (You may
need to precede it with http://). If you don't know the current IP address, find it by
printing a configuration
2. Click on the
3. On the
4. Set the
5. Enter the new IP address the the
6. Since you will lose your connection to the embedded web server when you change the
address, you can re-establish the connection by entering the new IP address in your
browser's URL field.
If you are moving the print server to another IP network:
1. First, do one of the following:
2. Then
3. Finally, do one of the following:
Performing a cold reset (to factory defaults):
Once you configure the print server, the configuration settings are retained in memory unless you
manually reset them to factory defaults, as follows:
1. Unplug the power module from the back of the print server.
2. While holding down the test button
back into the print server and continue to hold down the test button
seconds. Any user-configured settings will be erased.
page.
tab in the page that then appears in the browser.
Networking
page, make sure that
Networking
IP Configuration Method
Change the IP address to one usable on the new network:
address.) Verify the
network, or fix them.
Erase the current IP address and configure another address after you are
installed on the new network.
and
Mask Default Gateway
reset the print server to factory defaults.
If the print server was configured using BOOTP or DHCP, edit the appropriate
system files with updated settings. If the current BOOTP server is not reachable,
you may need to locate and configure a different BOOTP server.
If the IP address and other parameters were manually set, then manually
reconfigure them.
.
Default Gateway
TCP/IP
to .
Manual
box.
IP Address
and
Subnet Mask Default Gateway
(How to set the IP
are usable with the new address, or fix them.
(How to set the IP address.) Verify the
on the back of the print server, plug the power module
©2000, 2001, 2002 Hewlett-Packard Company
is selected.
(How to set the IP
are usable with the new
address.) Verify the
Subnet Mask
button for about five
Subnet
and