Check Mmc Files And Storage Space; Communications Port Configuration - Eagle INTELLIMAP 502 C IGPS Installation And Operation Instructions Manual

3. To change distance settings, scroll
gory, then press → |
↓ to change the first character, then press → to the next character and
repeat until the name is correct.
4. When your adjustments are finished, return to the last page dis-
played by repeatedly pressing
IMPORTANT ALARM NOTES:
Anchor Alarm - The anchor alarm may be triggered even when
you're sitting still. This typically happens when using small (less
than .05 mile) anchor alarm ranges.
Arrival Alarm - If you set the arrival alarm's distance to a small
number and you run a route (see the Navigate Routes segment),
this unit may not show navigation data to the next waypoint, once
you arrive at the first one, since you may not be able to come close
enough to the first waypoint to trip the arrival alarm.

Check MMC Files and Storage Space

To check MMC Files:
Press |
MENU MENU
| to see the free space on the card.
I ENT
NFO

Communications Port Configuration

The unit has one NMEA 0183 version 2.0 compatible communication
port, or com port for short. The Com Port Menu, which is accessed from
the System Setup Menu, lets you configure the communications port to
send or receive data to another electronic device, such as an autopilot.
The com port can be used for NMEA Binary data transfer.
to activate the distance dialog box. Press ↑ or
ENT
|↓ to
B
ROWSE
Main Menu, left, MMC File Browser, right.
↓ ↑
or
.
EXIT
|
MMC F
ILES
70
to select the desired cate-
. Press ↓ to
ENT MMC C
ARD