Advanced; Di And Do - D-Link DCS-3716 User Manual

Configuration
This screen allows you to control the behavior of digital input and digital output devices. The I/O connector provides the physical interface for
digital output (DO) and digital input (DI) that is used for connecting a diversity of external alarm devices such as IR-Sensors and alarm relays. The
digital input is used for connecting external alarm devices and once triggered images will be taken and e-mailed.
Select.D/I.or.D/O.Mode:
Video.Output:
D-Link DCS-3716 User Manual
The camera will send a signal when an event is
triggered, depending upon the type of device
connected to the DI circuit.
N.C. stands for Normally.Closed. This means that the
normal state of the circuit is closed. Therefore events
are triggered when the device status changes to
"Open."
N.O. stands for Normally.Open. This means that the
normal state of the circuit is open. Therefore events
are triggered when the device status changes to
"Closed."
LED:
You may specify whether or not to illuminate the LED
on the side of the camera.
Enable/ disable the BNC terminal TV output signal.
D/I.and.D/O
Pin.Block

Advanced

DI and DO

42