Hardware Installation - D-Link DCS-3430 User Manual

Section 1 - Product Overview

Hardware Installation

Attach the Antennas (DCS-3430 only)
Locate the antennas included with your DCS-3430, and attach them to the antenna connectors
located on the back of the DCS 3430.
Connect the Ethernet Cable
Connect an Ethernet cable to the network cable connector located on the Network Camera's
back panel and attach it to the network.
Attach the External Power Supply
Attach the external power supply to the DC power input connector located on the Network
Camera's back panel (labeled DC 12V) and connect it to an AC power outlet.
Note: When you have a proper connection, the LED will turn green. The light may cycle on and off
and your computer may show an intermittent loss of connectivity, this is normal until you have
configured your Network Camera.
Connect Using Power-Over-Ethernet
Once you connect an Ethernet cable to your PoE switch or adapter, the Power LED on the DCS-3411/3430 will turn green to
indicate a proper connection.
D-Link DCS-3411/3430 User Manual 7