Denon DVD-2910 Operating Instructions Manual page 15

(5) Connecting to a Digital Recorder (MD Recorder, DAT Deck, etc.)
Set the "AUDIO SETUP" default setting as shown below. (See pages 34 ~ 37.)
• "DIGITAL OUT" → "PCM"
"LPCM (44.1kHz/48kHz)" → "ON"
Playing DVDs with incorrect settings may result noise that could damage your ears or the speakers.
DVD-2910/955
NOTE:
• Digital audio signals cannot be output when playing Super Audio CDs. Use analog connections to record Super Audio CDs.
(6) Connecting to a Stereo Component
DVD-2910/955
NOTE:
• When connecting to a 2-channel audio stereo device using the 5.1ch AUDIO OUT, set "AUDIO CHANNEL" under "AUDIO
SETUP" on the "SETUP" menu to "2CH (SRS OFF)" or "2CH (SRS ON)" (See page 34.). For multi-channel sources, the signals
are down-mixed into two channels (analog).
(Only the front left and right channels are output for sources for which down-mixing is prohibited.)
Optical fiber cable (commercially available)
(or)
75Ω/ohms pin-plug cable (commercially available)
B
Digital audio Digital audio
input connector input connector
(OPTICAL) (COAXIAL)
Stereo component
ENGLISH
8 9
15