Control; Remote Power/Reset; Console; Kvm/Vm - LaCie 12big Rack Storage Server User Manual

LaCie 12big Rack Storage Server
User Manual

5.4. Control

5.4.1.

Remote Power/Reset

This section allows you to power down, shutdown, reset and power
cycle the board.
Table 12 - Enclosure Impact
Command Payload Impact
Reset Immediately reboots the enclosure in the
same way as pressing the Reset button.
Power Cycle Powers down and restarts the enclosure.
The current POST value is also displayed on this page.

5.5. Console

5.5.1.

KVM/VM

This section gives access to the KVM and the VM.
5.5.2.

KVM

To start the KVM, click on the button
A small Java file will be downloaded to the computer. A safety warn-
ing may pop up and ask if the application can be started. Answer
Yes to continue. A new window will appear and display what is
shown on the computer (12big Rack Storage Server-ATX).
The motherboard can be managed from any remote computer.
The mouse needs to be configured depending on the installed op-
erating system. To do so, when the KVM is started, click on Tools,
located on the menu bar, then on
OS in the Mouse Acceleration
5.5.3.

Virtual Media

To start the Virtual Media, click on the button
Java file will be downloaded to the computer. A safety warning may
pop up and ask if the application can be started. Answer
continue. A new window will appear in which all physical drives on
the computer are listed.
A drive image can be added by clicking the
this menu, select the ISO or IMG file to be mounted. To map a
drive, check the corresponding box in the window. The device will
be detected as a USB device. An operating system installation can
be done remotely by mapping the source file.
KVM (Keyboard Video Mouse).
Mouse and select the appropriate
section; then click OK.
Virtual Media. A small
Add image button. In

5.6. Maintenance

5.6.1.

Component Upgrade

This section allows the firmware of the Web Management Interface
to be upgraded.
1. Click Browse...
on File Upload.
Fig. 26 - Firmware Upgrade Step 1
2. When the file is uploaded, the file information will be displayed.
At this point it is possible to select the component to upgrade.
Yes to
Fig. 27 - Figure 5–2 Firmware Upgrade Step 2
The Management GUI
and select the .hpm file to upload. Then click
page 27