Programming A Member List - Yaesu FTM-10R Operating Manual

(Requires all members set the same member list (includes own ID) into the same member
box in the same order.)
It is possible to register a maximum of 20 persons, in order to identify the sender. When
you receive a message transfer, you can know who sent the message by the ID in the regis-
ter. In addition, your ID can be sent to the members when you transmit any messages to
them.
If all the members share the register information (ID), the message sender ID will be shown
on the display when receiving the message.
Even if no IDs are registered, the function can work. In this case "MEMBER 1" though
"MEMBER 20" will be displayed, when receiving a message.
We recommend that you use your call sign for the member list.
1. Press and hold the [ VOL/SEL ] key for one second to activate the Menu mode.
When the display indicates the Clock, Stop Watch Timer, or Temperature, press the
[ VOL/SEL ] key to change to the VFO or memory mode, then perform the above step.
2. Rotate the DIAL knob to select Menu Item "F16 ID LIST".
3. Press the key to enable selection of this Menu Item.
4. Rotate the DIAL knob to select the desired member box (1
~ 20) into which you wish to store a member ID. The LCD
will display the previously stored member ID.
5. Press and hold the
Press the PTT key to clear the previously stored member
ID, if desired.
6. Rotate the DIAL knob to select the first character of the
personal ID you wish to store, and then press the
briefly to save the first character of the personal ID and
move on to the next place.
7. Repeat previous step to complete the personal ID (up to 8
characters). If you make a mistake, press the
move back to the incorrect character, then re-enter the cor-
rect character.
Press the PTT key to delete all data after the cursor that may have been previously
stored erroneously.
8. When the personal ID entry is complete, press and hold in the
If you decide to cancel programming a member ID, press the [ VOL/SEL ] key, exit to
normal operation.
9. If you wish to store another personal ID, repeat steps 4 through 8 above.
10. Press the [ VOL/SEL ] key to save the new setting and exit to normal operation.
FTM-10R O
PERATING
P
ROGRAMMING A
key for one second.
M
ANUAL
M
ESSAGE
M L
EMBER IST
key
key to
F
EATURE
Number of Member box
key for one second.
47