Frequency Display - Yaesu FT DX 9000 CONTEST - MANUAL 2 Operation Manual

F
REQUENCY
VFO-A TX/RX Indicators
These combination lamp-buttons select and indicate
the transmit/receive status of the VFO-A. When the
green "RX" lamp is lit, the receiving frequency is un-
der control of the Main Tuning Dial (#
play (either VFO-A or a recalled memory channel).
When the red "TX" lamp is lit, the transmitting fre-
quency is under control of the main knob and display.
Thus, for "normal" (non-split) operation, both the red
and green lamps associated with the Main Tuning
Dial will be illuminated.
VFO-A Frequency Display
This is the VFO-A frequency display.
Advice
The Tone Encoder/Decoder frequency is indicated
during the setup process.
VFO-B TX/RX Indicators
These combination lamp-buttons select and indicate
the transmit/receive status of the VFO-B.
VFO-B Frequency Display
This is the VFO-B frequency display.
Advice
The Tone Encoder/Decoder frequency is indicated
during the setup process.
Page 36
D
ISPLAY
) and dis-
Multi-Panel
This field within the frequency display area provides
several indications, depending on the frequency con-
trol mode in use:
CLAR (Clarifier)
This window displays the Clarifier frequency offset
from the VFO-A frequency. The Clarifier is engaged
when the CLAR LED is illuminated.
MR (Memory Recall)
When the MCH/GRP switch is pushed, the cur-
rently-selected Memory channel or Memory Group
number will be displayed in this window.
MT (Memory Tune)
If you rotate the Main Tuning Dial (#
the mode) during memory operation, the transceiver
will change into the "Memory tune" mode to indicate
that the memory contents have been temporarily
changed; " " lights up to confirm this change.
Repeater Shift Data
During FM operation, the Repeater Shift will be indi-
cated in this window.
A Negative frequency shift will be indicated by "–"
while a Positive frequency shift will be indicated by
"+" in the window. During Simplex operation (no
shift), "S" will be displayed.
FT 9000 C
DX ONTEST
) (or change
O M
PERATION ANUAL