(Ssb/Cw/Rtty/Pkt Modes); Using If Shift And Width Together - Yaesu FT DX 9000 CONTEST - MANUAL 2 Operation Manual

I
NTERFERENCE
WIDTH ( IF DSP B
The IF Width tuning system allows you to vary the width of the DSP IF passband, so as to eliminate interference. Moreover,
the bandwidth may actually be expanded from its default setting, should you wish to enhance incoming signal fidelity when
interference on the band is low.
Rotate the WIDTH knob (#
Counter-clockwise rotation reduces the bandwidth, while
clockwise rotation increases the bandwidth.
By rotating the WIDTH knob to the left, the bandwidth will
narrow (see Figure (A)), while rotation of the WIDTH knob to
the right, as depicted in Figure (C), will widen the bandwidth.
The default bandwidths, and total bandwidth adjustment range,
will vary according to the operating mode:
SSB Mode
200 Hz ~ 4.0 kHz (bandwidth at 12 o'clock position of WIDTH :
2.4 kHz).
CW/RTTY/PKT Modes
25 Hz ~ 2.4 kHz (bandwidth at 12 o'clock position of WIDTH :
500 Hz).
A
IF BANDWIDTH IF BANDWIDTH
The IF Shift and Variable IF Width features together form a very effective interference-fighting filtering system.
For example, in Figure (A) you can see how interference has ap-
peared both on the high and low sides of the desired signal. By ro-
tating the WIDTH control, as shown in Figure (B), the interfer-
ence from one side can be eliminated, and by re-positioning the
SHIFT control (Figure (C)), the interference on the opposite side
can be removed, without re-introducing the interference previously
eliminated in Figure (B).
Advice
For best interference reduction, the Width and Shift features are the
primary tools you should use. After narrowing the bandwidth (Width)
and/or adjusting the center of the passband (Shift), the Contour con-
trol may also yield additional signal-enhancement benefits on the
net residual bandwidth. What's more, the IF Notch Filter (see the
next section) may also be utilized, in conjunction with the three
other filter systems, to significant advantage.
Page 58
R
EJECTION
) T
ANDWIDTH
) to adjust the bandwidth.
C
B
IF BANDWIDTH

Using IF Shift and Width Together

(S
IGNALS WITHIN
( SSB/CW/RTTY/PKT M
UNING
Advice
You may observe the effects of adjustment of the
WIDTH control on the LCD.
A
Desired Signal
QRM
QRM
QRM
IF BANDWIDTH
FT 9000 C
DX ONTEST
3 )
KHZ
ODES
WIDTH system may be
observed on the LCD
WIDTH knob
WIDTH system may be
observed on the LCD
C
B
QRM
QRM
IF BANDWIDTH IF BANDWIDTH
O M
PERATION
)
QRM
ANUAL