Yaesu FT DX 9000 CONTEST - MANUAL 2 Operation Manual page 142

D R
UAL ECEIVE
D S
IAL
Using the Menu, it is possible to change the RF GAIN control (for the VFO-A) to serve as the VFO-B AF GAIN
control. In this case, the Menu Item "GENERAL 038 AF/RF DIAL SWAP" will move the VFO-A RF GAIN control
function to the knob normally utilized for the VFO-B receiver's AF GAIN control. In this way, both the VFO-A and
VFO-B AF GAIN controls will be on the same shaft, as will the two VFOs' RF GAIN controls, and this may be
particularly useful during Dual Receive operation.
VFO-A
RF GAIN knob
Dial Swap Setup
1. Press the MNU key (#
mode; the Menu list will appear on the LCD Display.
2. Rotate the Main Tuning Dial (#
item "GENERAL 038 AF/RF DIAL SWAP."
3. Rotate the CLAR/VFO-B knob (#
lect "SWAP" instead of the factory-default "NOR-
MAL" selection.
4. Press and hold in the MNU key (#
onds to save the new configuration and exit to normal
operation.
Quick Point
If the Dial Swap function has been engaged, the VFO-A
AF GAIN RF GAIN control (#
reconfigured so that it now operates as AF GAIN (VFO-
A) AF GAIN (VFO-B); the VFO-B AF GAIN
GAIN control (# ) will now be configured as RF GAIN
RF GAIN (VFO-B).
(VFO-A)
Page 140
U
NIT
C
WAP ONFIGURATION
VFO-B
RF GAIN knob
) to engage the Menu
) to select Menu
) so as to se-
) for two sec-
) will be
RF
( RXU-9000 )
( AF/RF GAIN
VFO-A
AF GAIN knob
FT 9000 C
DX ONTEST
)
CONTROLS
VFO-B
AF GAIN knob
Main Tuning Dial MNU key
CLAR/VFO-B Knob
O M
PERATION ANUAL