Activating The Added Memory In The Ps Printer Properties - Ricoh 3200SF - Multifunctional SP Network-Ready User Manual

6 Push the DIMM straight into the DIMM slot until it snaps into place.
Make sure the latches fit over the notches located on either side of
the DIMM.
7 Replace the control board cover.
8 Reconnect the power cord and printer cable, and turn the machine
on.
Activating the added memory in the PS printer
properties
After installing the memory DIMM, you need to select it in the printer
properties of the PostScript printer driver so that you can use it.
1 Make sure that the PostScript printer driver is installed on your
computer. For details about installing the PS printer driver, see the
Software section.
2 Click the Windows Start menu.
3 For Windows 98/Me/NT 4.0/2000, select Settings and then
Printers.
For Windows XP, select Printers and Faxes.
4 Select the Printer Driver Type 104 PS printer.
5 Click the right mouse button on the machine icon and select
Properties.
6 For Windows 98/Me, select Device Options.
For Windows NT 4.0/2000/XP, select Device Settings.
7 Select the amount of memory you installed from Printer Memory in
the Installable Options section.
For Windows 98, select Installable Options
change setting for:VMOption
8 Click OK.
15.2
<Installing accessories>
VMOption
change memory.