Rugged Ridge 11540.11 Manual

Jeep
®
Contents:
1. Bumper Center Section (1)
2. Right Stubby End (1)
3. Left Stubby End (1)
4. D-Ring (2)
5. M12 x 60 Bolt (8)
6. M12 Washer (22)
7. M12 Lock Nut (14)
8. M3 Lock Nut (8)
9. M3 Washer (8)
10. M8 Washer (8) *
11. M8 x 20 Bolt (8) *
* Note - These components are only used when installing top mounted add-on pieces.
1. Disconnect fog lights by twisting the plug in the rear of them. Remove 4 nuts per frame horn that hold
the original front bumper to the vehicle. Remove original bumper.
2. Install the original fog lights into the Center Section from the back (Figure 2a). Use the (8) M3 lock
nuts and M3 washers to secure them (Figure 2b).
JK Wrangler Modular HD Front Bumper - No Winch
2
7
4
5
Figure 2a
9
Page 1 of 3
Figure 2b
11540.11
11
10
8
1
3
6