Rugged Ridge 11546.20 Quick Start Manual

Contents:

1. Rear HD Bumper (1)
2. Left Bracket (1)
3. Right Bracket (1)
4. D-Ring (2)
5. 12mm Washer (9)
6. 12mm Bolt (9)
7. Plugs (6)
8. Nut Plate (1)
1. Remove original rear bumper. It is held in by 2 bolts on each side (Figure 1a), and 2 bolts that are
attached to brackets which fasten to the rear crossmember (Figure 1b). After the bumper is
removed, remove the small brackets from the rear crossmember (Figure 1c). Save the 4 bolts
from the side and the 2 bolts from the crossmember, as they are to be re-used.
Figure 1a
2. Place Bracket on rear frame rails. Brackets need to be angled up while slid over frame rail
(Figure 2a), and then dropped down to level once crossmember hook has been cleared. (Figure 2b).
Use bolts removed in Step 1 to bolt brackets to frame (Figure 2c). Two bolts are used to fasten
bracket to frame rail, and one to fasten bracket to rear crossmember. Do not tighten bolts yet.
Figure 2a
Jeep JK Wrangler Rear HD Bumper
®
4
5
6
Page 1 of 2
1
Figure 1b
Figure 2b
11546.20
2
Figure 1c
Figure 2c
7
3
8