curt 12008 Manual

12008
1/17/2011
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH:
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY AUXILIARY STABILIZING STRAPS.
** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT
Parts List
ITEM QTY PART NUMBER
1 1 1/2-13 HANDLE NUT
2 1 1_2 FISHWIRE 1/2" FISHWIRE
3 1 3/8 - 16 x 2 HEX BOLT
4 1 3/8" WASHER
5 1 HFN3816 HEX FLANGE NUT
6 1 1/2 - 13 x 1 1/2 HEX BOLT
7 1 1/2" CONICAL TOOTHED WASHER
8 3 HFN 1213 HEX FLANGE NUT
9 3 CM-SP1 .250 x 1.50 x 2.00" SQUARE HOLE SPACER
10 2 CM-SP7 .250 x 1.00 x 2.00" SQUARE HOLE SPACER
11 3 1/2-13 x 1 3/4 CARRIAGE BOLT
12 1 M8 - 1.25 x 55mm HEX TAP BOLT
13 1 3/8" LOCK WASHER
14 1 CM-EHB1 .250" EXHAUST HANGER BRACKET
EXISTING ACCESS
SLOT
EXISTING MOUNTING
HOLES
8
PASSENGER'S SIDE ARM
ATTACH ONE END OF THE
EXHAUST HANGER TO THE
HITCH SIDE ARM USING
3/8" HARDWARE PROVIDED
39
HITCH WEIGHT: LBS.
INSTALL TIME
PROFESSIONAL: 60 MINUTES
NOVICE (DIY): 120 MINUTES
INSTALL NOTES:
-NO DRILLING REQUIRED
-LOWER EXHAUST
-FISHWIRE HARDWARE
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
36188
85-96 OLDS CUTLASS CIERA, 85-91 PONTIAC 6000
DESCRIPTION
11
9
10
2
PUSH THE SPACER BLOCK UP
TO THE HEAD OF THE BOLT
BEFORE POSITIONING INTO
THE MOUNTING HOLE.
3,500 LBS. TRAILER WEIGHT &
1-800-798-0813
5
7
6
4
3
DESIGNED FOR USE WITH
BALL MOUNT # D-19 / 45519
EXISTING WELD NUTS
RE-ATTACH AFTER
HITCH INSTALLATION
PAGE 1 OF 2
350 LBS. TONGUE WEIGHT.
EXISITING BUMPER
MOUNTING BOLT PLATE
(BEND AS REQUIRED)
1
13
12
14
CUT EXHAUST HANGER
BETWEEN HOLES
RETURN THIS SIDE
TO VEHICLE OWNER
ATTACHES TO HITCH