Kraus ST-4 Installation Instructions

PUSH
PUSH
OK
OK
Installation Instructions
Kraus Kitchen Sink Strainer
Pull knob & basket assembly
1
Step 1: Remove the pull knob and basket
assembly
Main connecting screw
2
Step 2: Disassemble the outlet by removing
the main connecting screw (screw will be
reinstalled in Step 5)
Stainless steel outlet top
3
Step 3: Separate the parts and place the
stainless steel outlet top and center it in the
90mm sink hole from above
Note: Seal between underside of strainer
body ange and inside of sink with plumber's
putty (not included)
Large rubber washer
4
Step 4: Fit the large washer inside the top rim
of the plastic underbody and center it on the
sink hole from underneath
Step 5: Fit the main connecting screw from
above and tighten
Step 6: Replace the pull knob and basket
assembly and test for leaks
Step 7: Connect to waste plumbing according
to relevant plumbing regulations
TURN
5
Plastic underbody
AND
PULL
TURN
AND
PULL
!
!
10
max
5Nm
CENT
10
max
5Nm
CENT
ST-4
Rev May 2017