Congratulations on the purchase of your Lefant ROBOTS!
We hope it brings you satisfaction. We trust your purchase will
keep your home clean and provide you a high-quality
life.
Should you encounter situations that have not been properly
addressed in this User Manual, please contact our
Customer Service Center, we will solve your specific problem. For
more information, please visit the Lefant ROBOTICS
official website: www.lefant.com or send email to the following
email address: support.us@lefant.com.
The Company reserves the right to make technological and/or
design changes to this product for continuous improvement.
IMPORTANT SAFETY INSTRUCTIONS
WARNING: Read all safety warnings and instructions. Failure to
follow the warnings and instructions may result in
electric shock, fire or serious injury.
READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE.
For Household use only
When using an electrical appliance, basic precautions should
always be followed, including the following:
1. The robot must be used in accordance with the directions in this
User Manual. Our company cannot be held liable or responsible for
any damages or injuries caused by improper use.
2. Do not allow to be used as a toy. Close attention is necessary
when used by or near children.x
Do not allow children to sit on the vacuum.
3. Clear the area to be cleaned. Remove power cords and small
objects from the floor that could entangle the Robot. Tuck rug
fringe under the rug base, and lift items such as curtains and table
cloths off the floor.
4. If there is a drop off in the cleaning area due to a step or stairs,
you should operate the Robot to ensure that it can detect the step
necessary to place a physical barrier at the edge to keep the unit
from falling. Make sure the physical barrier is not a trip hazard.
5. Only use as described in this manual. Only use attachments
recommended or sold by the manufacturer.
6. Please make sure your power supply voltage matches the power
voltage marked on the Docking Station.
7. Do not handle or plug appliance with wet hands.
8. Non-rechargeable batteries are prohibited.
9. Do not use without dust bin and/or filters in place.
10. Do not operate the robot in an area where there are lit candles
or fragile objects on the floor to be cleaned.
11. Do not use and store in extremely hot or cold environments
(below -5°C /23°F or above 40°C/104°F). Please charge the robot
in temperature above 0°C/32°F and below 40°C/104°F. Follow all
charging instructions and do not charge the battery pack or
appliance outside of the temperature range specified in the
instructions. Charging improperly or at temperatures outside of the
specified range may damage the battery and increase the risk of
fire.
12. Keep hair, loose clothing, fingers, and all parts of body away
from any openings and moving parts.
13. Do not operate the robot in a room where an infant or child is
sleeping.
14. For INDOOR use ONLY. Do not use the robot in outdoor, commer-
cial or industrial environments. Do not use Appliance on wet
surfaces or surfaces with standing water.
15. Do not allow the robot to pick up large objects like stones, large
pieces of paper or any item that may clog the robot.
16. Do not use the robot to pick up flammable or combustible
materials such as gasoline, printer or copier toner, or use in areas
where they may be present.
17. Do not use the robot to pick up anything that is burning or
smoking, such as cigarettes, matches, hot ashes, or anything that
could cause a fire.
18. Do not put any object into openings. Do not use with any open-
ing blocked; keep free of dust, lint, hair, and anything that may
reduce air flow.
19. Take care not to damage the power cord. Do not pull on or
carry the robot or the Docking Station by the power cord, use the
power cord as a handle, close a door on the power cord, or pull
power cord around sharp edges or corners. Do not run the robot
over the power cord.Keep power cord away from hot surfaces. Do
not unplug by pulling on cord, To unplug, grasp the plug, not the
cord.
20. If the power cord is damaged, it must be replaced by the
manufacturer or its service agent in order to avoid a hazard.
21. Do not use the Docking Station if it is damaged.
22. Do not use the robot or the Docking Station if it is not working
properly, has been dropped, damaged, left outdoors, or come in
contact with water. It must be repaired by the manufacturer or its
service agent in order to avoid a hazard.
23. Turn OFF the power switch before cleaning or maintaining the
robot. Turn off all controls
24. The plug must be removed from the receptacle before clean-
ing or maintaining the Docking Station.
25. Remove the robot from the Docking Station, and turn OFF the
power switch to the Appliance before removing the battery for
disposal of the robot.
26. The battery must be removed and discarded according to
local laws and regulations before disposal of the robot.
27. Please dispose of used batteries according to local laws and
regulations.
28. Do not incinerate the robot even if it is severely damaged. The
batteries can explode in a fire.
29. When not using the Docking Station for a long period of time,
please unplug it.
30. Prevent unintentional starting. Ensure the switch is in the off
position before connecting to battery pack, picking up or carrying
the appliance. Carrying the robot with your finger on the switch or
energizing the robot that have the switch on invites accidents.
31. When battery pack is not in use, keep it away from other metal
objects, like paper clips, coins,keys, nails, screws,ect, that can make
a connection from one terminal to another. Shorting the battery
terminals together may cause burns or a fire.
32. Under abusive conditions, liquid may be ejected from the
battery; avoid contact. If contact accidentally occurs, flush with
water. If liquid contacts eyes, additionally seek medical help. Liquid
ejected from the battery may cause irritation or burns.
33. Do not use a battery pack that is damaged or modified. Dam-
aged or modified batteries may exhibit unpredictable behavior
resulting in fire, explosion or risk of injury.
34. Do not expose a battery pack or appliance to fire or excessive
temperature. Exposure to fire or temperature above 130°C/265°F
may cause explosion.
35. Have servicing performed by a qualified repair person using
only identical replacement parts.
36. Do not modify or attempt to repair the robot or the battery
pack (as applicable) except as indicated in the instructions.
37. Do not operate the robot in a room that has lit candles on
furniture that the vacuum may accidentally hit or bump into.
38. Recharge only with the charger specified by the manufacturer.
A charger that is suitable for one type of battery pack may create
a risk of fire when used with another battery pack.
39. Use the robot only with specifically designated battery packs.
Use of any other battery packs may create a risk of injury and fire.
40. The robot contains batteries that are only replaceable by
skilled persons. To replace the robot's battery, please contact
Customer Service.
41. If the robot is not going to be used for a long time, fully charge
the robot, power it OFF, and unplug the Docking Station.
SAVE THESE INSTRUCTIONS
To satisfy RF exposure requirements, a separation distance of 20
cm or more should be maintained between this device and per-
sons during device operation.
To ensure compliance, operations at closer than this distance is not
recommended. The antenna used for this transmitter must not be
co-located in conjunction with any other antenna or transmitter.
S
Correct Disposal of this Product
This marking indicates that this product should not be disposed of
with other household waste throughout the EU. To prevent possible
harm to the environment or human health from uncontrolled waste
disposal, recycle it responsibly to promote the sustainable reuse of
material resources. To recycle your used device, please use the
return and collection systems or contact the retailer where the
product was purchased. They can safely recycle this product.
Federal Communications Commission
(FCC) Interference Statement
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generate, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful inter-
ference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try
to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may
cause undesired operation.
FCC Caution:
Any changes or modifications not expressly approved by the party
responsible for compliance could void the user 5s authority to
operate this equipment.
RF exposure warning
This equipment complies with FCC radiation exposure limits set
forth for an uncontrolled environment.This equipment must be
installed and operated in accordance with provided instructions
and the antenna(s) used for this transmitter must be installed
antenna(s) used for this transmitter must be installed to provide a
separation distance of at least 20 cm from all persons and must
not be collocated or operating in conjunction with any other
antenna or transmitter.
Short-circuit-proof safety isolating transformer
Switch mode power supply
For indoor use only
Direct current
Alternating current
detachable supply unit
Need help?
Do you have a question about the M1 and is the answer not in the manual?
Questions and answers