Set Up The Mixer For Stereo Operation (If Using Two Channels Of A Mixer) - DigiTech VOCALIST LIVE 2 Owner's Manual

4. Turn on your amplifier and gradually turn it up until you reach a comfortable listening level.
5. Turn on your P.A. system and gradually turn it up until you reach a comfortable listening level.
6. While playing a chord on your guitar, sing a note. You should hear your guitar and your voice,
plus a harmony voice. If not, repeat the steps above or consult the Troubleshooting section on
page 22.

Set up the Mixer for Stereo Operation (If Using Two Channels of a Mixer)

1. Turn the Vocalist
2. Set the mixer channels' faders to 0dB.
3. Set the mixer's master fader to its minimum position (no output signal).
4. Set the pan controls on the selected mixer channels hard left and hard right.
While singing, gradually turn up the Vocalist Live 2's Mic/Line Input Level knob until the
5.
Vocal Signal LED lights amber most of the time, and red during the loudest parts only. (For
more information about setting levels, see page 21.)
6. Gradually bring the mixer's master fader up until you reach your desired level.
Live 2 Mic/Line Input Level knob completely counter-clockwise.
®
11