Set The Vocalist ® Live 2 Controls - DigiTech VOCALIST LIVE 2 Owner's Manual

Set the Vocalist
1. Turn the Compressor, Reverb, and Enhance knobs all the way down (counter-clockwise).
2. Turn the Harmony Mix knob to the 11 o'clock position.
3. Power up the Vocalist
4. Press the High button so that it is lit.
5. Press the HARMONY FOOTSWITCH so that the HARMONY LED just above it is lit.
Adjust Levels and Tune Your Guitar
1. Observe the Guitar Signal LED while playing your guitar. Adjust the output level of your
guitar until the Guitar Signal LED lights green or amber most of the time. (For more infor-
mation about setting levels, see page 21.)
2. Perform the obligatory "Check 1-2" or sing into the mic while gradually turning up the Vocal-
ist Live 2 Mic/Line Input Level knob until the Vocal Signal LED lights amber most of the
time. (For more information about setting levels, see page 21.)
Press and hold the EFFECTS FOOTSWITCH until the TuNING LEDs light up. Tune
3.
each string until the center (green LED below the triangle) LED illuminates for each string,
indicating it's in tune.
NOTE: It is important that your guitar is properly tuned in order to get the best
sounding harmonies. Alternate tunings such as DADGAD are fine, as long as the
tuning system used specifies a frequency of 440 Hz for A (A440), and it is based
on the chromatic scale (12 notes per octave). Micro-tonal scales are not sup-
10
ported.
Live 2 Controls
®
Live 2 by connecting the PS0913B power supply.
®