Respond Module Configuration-26(H); Receive Key Scan Code (54H); Receive Key Accepted (56H); Select One Program (1Fh) - DigiTech 2112 Owner's Manual

RESPOND MODULE CONFIGURATION (26h)
SYS HEAD , 26(h) , nn1, nn2, cc(1st)1,cc(1st)2, ee(1st)1, ee(1st)2, ... cc(nth)1, cc(nth)2 , ee(nth)1, ee(nth)2, F7(h)
nn Number modules present in the algorithm
cc Class I.D. of the nth module in the algorithm
ee I.D. number of the effect currently loaded in the nth module (see pg. 12 for ID numbers)
Class I.D. Numbers for 2112
00(h) Preamp
01(h) 1/4 Effect Module
02(h) 1/2 Effect Module
03(h) 3/4 Effect Module
04(h) Whole Effect Module

RECEIVE KEY SCAN CODE (54h)

SYS_HEAD, 54(h), cc, F7(h)
cc Code for the Key Scan (note: there is only one byte, not two)
The Receive Key Scan Code procedure is used to emulate a button press on the front panel of the . See the
Key Scan Code Maps (page 11) for a list of Key Scan codes.
RECEIVE HOLD KEY SCAN CODE (55h)
SYS_HEAD, 55(h), cc, 68, F7(h)
cc Code for the Key Scan (note: there is only one byte, not two)
68 Time key is pressed expressed in 0.1 seconds increments (note: there is only one byte, not two)
The Receive Hold Key Scan Code procedure is used to emulate a button press and hold on the front panel
of the 2112.The device will respond with a Receive Key Accepted procedure.

RECEIVE KEY ACCEPTED (56h)

SYS_HEAD, 56(h), cc1, cc2, F7(h)
cc Code echoed for the Key Scan received. (00(h) if key is invalid)
The Receive Key Accepted procedure is sent from the 2112 in response and acceptance of a Receive Scan
Code Key or Receive Hold Scan Code Key procedure but is ignored if received by the 2112.

SELECT ONE PROGRAM (1Fh)

SYS_HEAD, 1F(h), yy1, yy2, zz1, zz2 F7(h)
When yy = 00(h) User bank is selected
When yy = 01(h) Factory bank is selected.
zz The Program number, 1-100 User (00-63(h)) or 1-191 Factory (00-BE(h))
This command behaves like a standard MIDI Program Change command, except that it allows the selection of
any Program in the 2112 without the use of mapping.

RESET PROGRAM (20h)

SYS_HEAD, 20(h), F7(h)
The Reset Program procedure causes the 2112 to reload the current saved program.
73