Tyger TG-FF8D4418 Manual

FENDER FLARE
PLEASE READ AND FOLLOW THIS APPROVED INSTRUCTION CARE-
FULLY BEFORE INSTALLATION. FAILURE TO DO SO MAY CAUSE
DAMAGE TO THE VEHICLE AND WILL INVALIDATE THE WARRANTY.
PRIOR TO INSTALLATION
• Remove contents from box. Verify all parts are present and free
from any defects or damage.
• Make sure installation is done on a non-abrasive surface to avoid
scratching the flare surface.
• Pre-fit each flare to the vehicle body to ensure they suit the
profile of the vehicle.
• Remove existing decals and mud flaps on the vehicle that may
interfere with flare installation.
• Make sure all flares and fender wheel well are clean as the
presence of dirt or sand may scratch auto body paint.
• Suggest removing the tire before installation for easier access.
• Do not use any harsh abrasive detergent to clean the flare.
PAINTING
Painted flares cannot be returned. Test fit before painting. We are
not responsible for any costs that may incur if flares were painted
without test fitting.
• Clean surface to be painted with a good grade degreaser. Do not
use lacquer thinner or any solvent based product.
• Wipe flare surface completely dry with a tack rag prior to paint.
• Application of plastic adhesion promoter for PP plastic as per
your paint system manufacturer's recommendations is required.
• Use a high quality enamel or polyurethane automotive paint to
paint the flares.
• Not recommend to paint the edge trim, but if desired use a flex
additive.
WARNING
Dirt or debris may become lodged between flares and vehicle's
fenders causing scratching and paint wear from vehicle vibration.
TYGER is not responsible for any damage, and installation is done
with buyer's understanding that this damage may potentially
occur.
SAFETY INFORMATION
• Before driving, ensure that flare is properly secured to vehicle.
• Do not use automatic "brush-style" car wash.
• Periodically check all components for tightness.
TG-FF8D4418
Customer Support: www.TygerAuto.com/Contact
1/6
Customer Support 1-866-340-3038
Tools Required
1/2" Drill
8mm Socket
Hardware Included
x1 x36
[A] [B]
x1 x2
[F]
[E]
x1
[I]
DAMAGED or MISSING PARTS?
www.TygerAuto.com/Contact
TM
#2 Phillips Bit Utility Knife
Plastic Fastener
Remover
x36 x36
[C] [D]
x2 x2
[G] [H]
V200911