curt 11488 Manual

11488 / 247488
6/15/2009
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH:
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
ITEM QTY PART NUMBER
1 4 M10-1.25 x 35
2 4 7/16"
DRIVER SIDE FRAME RAIL
2
1
HITCH WEIGHT: 28 LBS.
INSTALL TIME: 20 MINUTES
INSTALL NOTES:
- NO DRILLING REQUIRED
- LOWER EXHAUST FOR EASE
OF INSTALLATION
INSTALLATION STEPS
1) Remove tow hooks from driver and passenger side frame rails if equipped. (Return to customer.)
2) Remove plastic push fastener from rear bumper fascia straps. (Reuse later.)
(Note: for ease of installation, remove rear exhaust hanger, until finished)
3) Raise hitch into position and secure with hex bolts and conical washers through existing weldnuts as shown.
4) Reinstall rear bumper fascia straps removed in step 2.
5) Torque all 10mm fasteners to 37 lb-ft. Re-install exhaust hanger previously removed.
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
04-06 SCION xA
Parts List
DESCRIPTION
HEX BOLT
CONICAL TOOTHED WASHER
EXISTING WELD NUTS
BUMPER FASCIA TABS
2,000
LBS. TRAILER WEIGHT &
PASSENGER SIDE FRAME RAIL
DESIGNED FOR USE WITH
BALLMOUNT #55001 / 45501
200
LBS. TONGUE WEIGHT.