curt 11487 Manual

11487
8/31/2009
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH:
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY AUXILIARY STABILIZING STRAPS.
** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT
Parts List
ITEM QTY PART NUMBER
1 4 M10-1.25 x 35
2 4 7/16"
3 1 1_4-20 x 1.00 HEX BOLT
4 1 1/4"
5 1 1_4 - 20
FRAME RAIL
2
1
HITCH WEIGHT: 30 LBS.
INSTALL TIME
15
PROFESSIONAL: MINUTES
30
NOVICE (DIY): MINUTES
INSTALL NOTES:
-NO DRILLING REQUIRED
-REMOVE TOW HOOKS
-REMOVE FASTENER
INSTALLATION STEPS
1. Remove tow hooks from driver and passenger side frame rails if equipped. (Return to customer.)
2. Remove plastic push fastener from driver side fascia strap and discard.
3. Raise hitch into position and secure with hex bolts and conical washers through existing weldnuts as shown.
4. Reinstall fascia strap using hex bolt, washer, and nylon lock nut.
5. Torque all 10mm fasteners to 37 lb-ft and all 1/4" fasteners to 8 lb-ft.
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
21487
04-07 SCION xB
DESCRIPTION
HEX BOLT
CONICAL TOOTHED WASHER
1/4-20 x 1.00 HEX BOLT
WASHER
NYLOCK HEX NUT
EXISTING WELDNUTS
5
4
3
DRIVER SIDE FASCIA STRAP
2,000 LBS. TRAILER WEIGHT &
1-800-798-0813
FRAME RAIL
EXISTING WELDNUTS
HITCH IS INSTALLED UNDERNEATH
PASSENGER SIDE FASCIA STRAP
(DO NOT REMOVE PLASTIC FASTENER
ON PASSENGER SIDE)
DESIGNED FOR USE WITH
BALL MOUNT # D-21 / 45520
200 LBS. TONGUE WEIGHT.