curt 11336 Manual

11336
9/01/2009
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH:
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY AUXILIARY STABILIZING STRAPS.
** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT
ITEM QTY PART NUMBER
1 3 HFN 1213
2 2 CM-SP28
3 2 1/2-13 x 1 1/2
4 1 1/2-13 x 1 3/4
3
2
EXISTING HOLES IN
SPARE TIRE WELL
1
HITCH WEIGHT: 16 LBS.
INSTALL TIME
30
PROFESSIONAL: MINUTES
60
NOVICE (DIY): MINUTES
INSTALL NOTES:
- NO DRILLING REQUIRED
- REMOVE/INSTALL SPARE TIRE
- REMOVE PLASTIC TRUNK SHIELD
INSTALLATION STEPS
1. Remove spare tire, plastic shield from trunk, bumper fascia tabs, and rubber trunk plugs.
2. Using silicone caulk, place a bead around interior holes in trunk to prevent intrusion of exhaust fumes and
water.
3. Place 1 1/2" carriage bolts and large spacers into existing trunk holes.
4. Raise hitch into position, sandwiching the tow loop between both mounting tabs on hitch.
Install all hex nuts as shown.
5. Torque all 1/2" fasteners to 75 lb-ft.
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
249336 / 247336
ACURA RL
Parts List
DESCRIPTION
HEX FLANGE NUT
.250 x 3.00 x 4.00" SQUARE HOLE SPACER
CARRIAGE BOLT
CARRIAGE BOLT
4
DESIGNED FOR USE WITH
BALLMOUNT #55001 / 45501
2,000 LBS. TRAILER WEIGHT &
PLASTIC SHEILD TRIMMING GUIDE
TRIM FASCIA ALONG BOLD LINE
3.000 in
9.250 in
AFTER SLITTING CENTERLINE
TRIMMING THIS PORTION IS
OPTIONAL
TOW LOOP
200 LBS. TONGUE WEIGHT.
1-800-798-0813
REMOVE THIS SECTION
9.500 in
RIBBED AREAS
CENTER LINE
OF VEHICLE
2.250 in
1.750 in