curt 11326 Manual

11326
9/01/2009
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH:
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY AUXILIARY STABILIZING STRAPS.
** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT
ITEM QTY PART NUMBER
1 1 3/8-16 x 1 1/4 LG.
2 1 3/8-16
3 2 CM-SP7
4 1 CM-SP48
5 1 CM-SP18
6 2 7/16-14 x 1 1/2
7 1 1/2-13 x 2"
8 2 7/16-14
9 1 HFN 1213
10 1 CM-438-FW
REAR OF VEHICLE
4.313 in
DRIVER SIDE
PLASTIC UNDER BODY PANEL
CUTOUT DIAGRAM
HITCH WEIGHT: 26 LBS.
INSTALL TIME
60
PROFESSIONAL: MINUTES
120
NOVICE (DIY): MINUTES
INSTALL NOTES:
- NO DRILLING REQUIRED
- LOWER AND TRIM FASCIA
INSTALLATION STEPS
1) Remove 2 fascia nuts from under body panel and lower panel from vehicle.
2) Trim under body panel as shown above.
3) Fishwire 7/16" carriage bolt and spacer into the passenger side frame.
4) Use 3/8" and 7/16" fasteners to secure the center of the hitch to the bumper beam tab.
5) Fasten driver side arm to top of tow loop using 1/2" bolt, spacer, and flange nut.
6) Torque all 1/2" fasteners to 75 lb-ft, all 7/16" fasteners to 50 lb-ft, and all 3/8" fasteners to 30 lb-ft.
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
249326 / 247326
SAAB 9-3 (SINGLE EXHAUST MODELS)
Parts List
DESCRIPTION
CARRIAGE BOLT
HEX FLANGE NUT
.250 x 1.00 x 2.00" SQUARE HOLE SPACER
.250 x 2.13 x 2.13" SQUARE HOLE SPACER
.250 x 1.00 x 2.00" SQUARE HOLE SPACER
CARRIAGE BOLT
HEX BOLT
HEX FLANGE NUT
HEX FLANGE NUT
7/16 " FISHWIRE TOOL
5.875 in
6.250 in
PASSENGER SIDE
4.500 in
9
TOW HOOK LOOP
2,000 LBS. TRAILER WEIGHT &
3
2
8
BUMPER BEAM TAB
4
10
7
200 LBS. TONGUE WEIGHT.
1-800-798-0813
PASSENGER SIDE FRAME RAIL
8
5
1
6
DESIGNED FOR USE WITH
BALLMOUNT #55001 / 45501
6
3