curt 11352 Manual

11352 NISSAN MAXIMA SEDAN AND ALTIMA SEDAN (INCLUDING HYBRID)
9/16/2009
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH:
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY AUXILIARY STABILIZING STRAPS.
** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT
Parts List
ITEM PART NUMBER
QTY
1 1 1/2"
2 4 CM-SP6
3 4 1/2-13 x 1
4 4 HFN 1213
HITCH WEIGHT: 27 LBS.
INSTALL TIME
PROFESSIONAL: 45 MINUTES
NOVICE (DIY): 90 MINUTES
INSTALL NOTES:
-LOWER EXHAUST
-DRILLING REQUIRED
-FISHWIRE HARDWARE
INSTALLATION STEPS
1) Remove the exhaust from vehicle:
A) Remove exhaust flange nuts(Fig A) and ground wire (if present) from muffler.
B) Pull each exhaust pipe/muffler assembly towrds rear of car until the exhaust hanger has
cleared the rubber isolator.
2) Remove the heat shields by drilling out the rivets securing them to the frame rails. (Return the
heat shields to the vehicle owner.)
3) Enlarge the holes in the frame rails as shown above to allow the CM-SP6 spacer and carriage bolt to
pass through.
4) Fishwire a 1/2-13 carriage bolt and CM-SP6 spacer through the enlarged hole into the existing rearmost
hole in each frame rail as shown.
5) Reverse Pull Fishwire fishwire a 1/2-13 carriage bolt and CM-SP6 spacer into
the enlarged hole in each frame rail as shown.
6) Raise the hitch into position over the fishwired hardware and secure with 1/2" flange nuts as shown.
7) Torque all hardware to 75 lb.-ft.
8) Reinstall exhaust removed in Step 1.
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
24737
DESCRIPTION
FISHWIRE TOOL
.250 x 1.00 x 3.00" SQUARE HOLE SPACER
CARRIAGE BOLT
HEX FLANGE NUT
EXHAUST FLANGE NUTS
ENLARGE HOLE
2,000 LBS. TRAILER WEIGHT &
1-800-798-0813
ENLARGE HOLE
Fig A
1
DESIGNED FOR USE WITH
BALLMOUNT #55001 / 45501
200 LBS. TONGUE WEIGHT.
2
3
4