WeatherTech BumpStep 81BS1 Instructions

BumpStep
HITCH MOUNTED BUMPER PROTECTION
Instructions
1
Slide the 2" square portion of your
BumpStep
®
with the grooved step surface
facing upwards.
3
Insert the WeatherTech
(or any commercially available
hitch pin) to secure your BumpStep
to the receiver.
©2016 by MacNeil IP LLC
into your 2" receiver
hitch pin
®
Questions? Call customer service at 630 769 1500
®
2
Align the BumpStep
hole position allowed by your receiver.
Note: If your BumpStep
in an impact or accident it is important to
have it inspected for cracks or fractures
prior to placing any weight or loads upon it.
Please send it to WeatherTech
Inspection, 1 MacNeil Court, Bolingbrook,
IL 60440 and we will be happy to inspect it
and advise you if it needs to be replaced.
Fully warranted to the original owner against
defects in materials and workmanship for
the lifetime of the product and specifically
excludes damage caused by impacts,
damage from car wash chemicals, etc.
®
to the deepest
®
has been involved
®
, BumpStep
®
Made in USA
®