Download Print this page

WeatherTech BumpStep XL Manual

Hitch mounted bumper protection

Advertisement

Quick Links

XL
HI T C H MOUNT E D BUMP E R P R OT E C T I O N
Cont e nt s I n cl u ded
Plated
Stainless Steel
Hardware
Hardware
(Available only with
(Available only with
I n st r uct i o ns
the BumpStep ® XL
the BumpStep ® XL
with Plated Hardware)
with Theft Deterrent
Insert the BumpStep ® XL to the hole
Slide the 2" square portion of
Remembering the hole determined in
your BumpStep ® XL into your
step 2, remove the BumpStep ® XL and
that allows for enough room to fit just
2" receiver with the grooved
the ball of the foot centered on top with
insert the nut into the corresponding
step surface facing upwards.
the tip of the shoe clearing the bumper.
hex hole on the side of the post.
Slide the BumpStep ® XL back into your
Tighten to a snug fit, do not over tighten
receiver and insert the bolt with lock washer
(approximately 30-40 ft/lbs of torque.)
under the head of the bolt, then the flat
For plated hardware, use 15/16" socket
washer. Flat washer can be eliminated if
or wrench. For stainless hardware,
there is a clearance issue on your vehicle.
use 1/2" hex key.
Note: If your BumpStep ® XL has been involved in an impact or accident, it is important
to have it inspected for cracks or fractures prior to placing any weight or loads upon it.
Please send it to WeatherTech ® , BumpStep ® XL Inspection, 1 MacNeil Court, Bolingbrook,
IL 60440 and we will be happy to inspect it and advise you if it needs to be replaced.
Fully warranted to the original owner against defects in materials and workmanship for
the lifetime of the product and specifically excludes damage caused by impacts,
damage from car wash chemicals, etc.
Questions? Call customer service at (630) 769-1500
Made in USA
©2017 by MacNeil IP LLC
67BSXL1

Advertisement

loading
Need help?

Need help?

Do you have a question about the BumpStep XL and is the answer not in the manual?

Questions and answers

This manual is also suitable for:

81bs1xlss