WeatherTech CupFone Manual

Installation Instructions

These instructions and the fitting process also apply to CupFone XL with Extension and Hand Sanitizer Holder.

1. CupFone with Extension and Hand Sanitizer Holder comes with several base cups to perfectly fit your vehicle's cupholder.
   
2. Before separating your base cups, ensure that the openings on the bottom are not staggered.
   
3. Twist all cups so that only one opening is visible on the bottom.
   
4. Line up the separator tool with the opening.
   
5. Press the cups down on the tool to pop out each cup.
   
6. Repeat step five until you find the right fit for your vehicle's cup holder, and then insert CupFone with Hand Sanitizer Holder into it.
   

7. Loosen the top knob behind the CupFone with Extension head, and then slide the holder until the width fits your phone. Tighten the knob.
   
8. Adjust the tilt with the middle knob.
   
9. Loosen the bottom knob and pull the extension up to your preferred height.
   
10. Adjust the angle of the extension arm to your optimal viewing position (only possible with full extension) and tighten the knob.
    
11. Swivel your CupFone with Extension and Hand Sanitizer Holder in the cup holder until you find the ideal view.