curt 11822 Manual

11822
9/11/2009
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH:
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY AUXILIARY STABILIZING STRAPS.
** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT
DRILL HOLE
HITCH WEIGHT: 18 LBS.
INSTALL TIME
20
PROFESSIONAL: MINUTES
NOVICE (DIY): 40 MINUTES
INSTALL NOTES:
-DRILLING REQUIRED
INSTALLATION STEPS
1. Mount hitch as shown fastening at car's tow loop using U-bolt. Do not use impact wrench on U-bolt.
2. Use hitch as a drill template and drill four holes through tire well floor.
3. Install fasteners as shown.
4. Torque all hardware to 50 lb.-ft.
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
24688 / 257247
00-04 VOLVO S40 & V40
ITEM
4
1
2
3
4
3
TIRE WELL
2
2,500 LBS. TRAILER WEIGHT &
1-800-798-0813
Parts List
QTY PART NUMBER
1 7_16 - 14 x 1.75" x 1.00" C-C
6 7/16-14
4 CM-SP1
4 7/16-14 x 1 1/2
DESIGNED FOR USE WITH
BALLMOUNT #55001 / 45501
200 LBS. TONGUE WEIGHT.
DESCRIPTION
U-BOLT
HEX FLANGE NUT
.250 x 1.50 x 2.00" SQUARE HOLE SPACER
CARRIAGE BOLT
1