curt 11808 Manual

11808
86-94 SAAB 900 CONVERTIBLE , 87-93 SEDAN & HATCHBACK (INCL. TURBO)
1/18/2011
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH:
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY AUXILIARY STABILIZING STRAPS.
** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT
TRUNK FLOOR AREA
EXISTING NUT PLATE
HITCH WEIGHT: 16 LBS.
INSTALL TIME
45
PROFESSIONAL: MINUTES
NOVICE (DIY): 90 MINUTES
INSTALL NOTES:
-NO DRILLING REQUIRED
INSTALLATION STEPS
1. Remove two existing 10mm screws at either side of the rear bumper bracket at the rear panel. On
certain models it will be necessary to remove a bolted on bracket under the floor at the rear center of the car.
2. Using fasteners as shown, mount the hitch to the car at the rear panel. Using fasteners and nut plate
provided, mount the hitch at the existng bracket under the floor.
3. Torque all 10mm fasteners to 36 lb-ft, and all 3/8" fasteners to 30 lb-ft.
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
257218
7
6
5
4
2,500 LBS. TRAILER WEIGHT &
1-800-798-0813
ITEM QTY PART NUMBER
1 2 M10 - 1.5 x 30 HEX
2 2 7/16
3 2 M10 - 1.50 HEX-NUT
4 2 3/8 - 16 x 1 1/4
5
2 3/8"
6 2 3/8"
7 1 CM-NP5W
3
2
DESIGNED FOR USE WITH
BALLMOUNT #55001 / 45501
200 LBS. TONGUE WEIGHT.
Parts List
DESCRIPTION
HEX BOLT
HELICAL LOCK WASHER
Hex Nut
HEX BOLT
LOCK WASHER
WASHER
SPACER WELDMENT ASSEMBLY
1