Related Manuals for Malmbergs Evon Ztart
Summary of Contents for Malmbergs Evon Ztart
- Page 1 27 012 38-41 Evon Ztart WiFi/Bluetooth/4G NOTE! Please read through the manual carefully before using the appliance and keep it for future reference.
-
Page 2: Table Of Contents
WiFi Charging Station for Electric Vehicles Content SAFETY AND WARNINGS Product Introduction 2.1 Product Features 2.2 Product Overview 2.3 Product Dimensions ACCESSORIES TECHNICAL SPECIFICATIONS INSTALLATION 7-12 5.1 Required Material 5.2 Required Tools 5.3 Installation Procedure 9-12 Configure the Charger 13-14 6.1 Residential Scenario 6.2 Commercial Scenario 13-14... -
Page 3: Safety And Warnings
SAFETY AND WARNINGS Caution • Failure to follow instructions may result in danger. • Children are prohibited from touching the charging station. • Do not disassemble the charging station while connected to the mains. • Install the charging station away from pyrotechnics, dusty or corrosive places. •... -
Page 4: Product Introduction
PRODUCT INTRODUCTION Evon Ztart is a versatile and advanced EV charger, suitable for domestic use, offering up to 22kW of superfast charging. This OCPP-compliant unit supports pay-to-charge options through a mobile app or RFID, managed via any OCPP back-office system. -
Page 5: Product Dimensions
2.3 Product Dimensions 210 mm 95 mm 62 mm ACCESSORIES When you receive the product, please ensure that the accessories are complete; if any are missing, please contact us. Wire ferrule Cable clip Wall plug M4x32 screw M3x12 screw (x5) (x1) (x4) (x4) -
Page 6: Technical Specifications
TECHNICAL SPECIFICATIONS Art.no. 27 012 38 27 012 39 27 012 40 27 012 41 Power supply 3P+N+PE Rated voltage 400V AC Input Rated current Terminal Max 10 mm Frequency 50/60Hz Output voltage 400V AC Maximum current Output power 22kW 22kW 11kW 11kW... -
Page 7: Installation
For and on behalf of: IEC 62321-7-2:2017, IEC 62321-6:2015, IEC 62321-8:2017, IEC 62321-12:2023 Residual Current Devices(RCD) IEC 62955: 2018 Malmbergs Elektriska AB, Sweden. RF & Health Mr. Anders Folke / Product Manager ETSI EN 300 328 V2.2.2, ETSI EN 300 330 V2.1.1, Date: 12/05/2025 ETSI EN 301 908-1 V15.2.1, ETSI EN 301 908-13... -
Page 8: Required Tools
5.2 Required Tools Before installation, you will need to prepare the following accessories and cables on your own: Tool Icon Function Tape ruler 5-meter Electric screw driver Approximately 2.2–2.8 Nm Hammer Standard 16 oz (450 g) Wire stripper Multimeter Spirit level Marker Electric drill 6 mm drill bit... -
Page 9: Installation Procedure
5.3 Installation Procedure Remove the core box from the enclosure. Drill holes and install the mounting bracket. 1. Affix the positioning diagram to the wall and mark the spots corresponding to the holes indi- cated on the diagram. 2. Create three holes at the marked locations using a drill. 3. - Page 10 Connect AC input power cable • Confirm the cable routing As shown below, the cable can be routed into the charger from rear or bottom or top. Top cabling (Max 5G6) Bottom cabling (Max 5G6) Rear cabling (Max 5G6) • If you choose bottom cabling, please replace the rubber plug in the charger with the cable gland to secure the cable.
- Page 11 • Strip the wires and clamp the wire ferrules. Pierce the rubber plug, then thread the cable through the opening. Recommended cable / Wire stripping length: 20 mm Bottom cabling 85 mm Rear cabling 115 mm Top cabling 115 mm •...
- Page 12 • Connect Ethernet cable for networking Daisy chain T568A T568B Router/Switch 20 (Max) Please ensure that the Ethernet signal strength does not fall below 100Mbps for each charger and that the charging is working. • Connect Ethernet cable for LBC UDP communication T568A T568B Router/Switch LBC box...
-
Page 13: Configure The Charger
6 CONFIGURE THE CHARGER 6.1 Residential Scenario Evchargo App is recommended for the charger used in a residential scenario. For an installer, you can download and install Evchargo App, and after completing all necessary configurations, you can transfer the ownership to the user. The user then simply install the App and log in to easily control the charging process with the App. - Page 14 Press the 'Reset' button if needed as shown below, and that it will do self test (leakage test) Press the "Reset" button twice within 2s to reboot and reactivate the WiFi hotspot. Press the "Reset" for 5s to reset the PIN codes for AP and Bluetooth password. 6.2.2 Evchargo cloud platform For managing your chargers after network setup, you might find it beneficial to use a smart manage- ment platform.
-
Page 15: Unlock Charging Connector
UNLOCK CHARGING CONNECTOR In case the charging connector gets stuck and connot be removed from the EV charger, follow the instructions below to safely release it. 1. Cut off the power supply. 2. Remove the enclosure. 3. Use a flat-head screwdriver to lever the rocker arm off and unlock the charging connector. -
Page 16: Indicator
INDICATOR Indicator color EV charger status Indicator status Standby Cycle: slow flashing: on for 1s, then off for 3s. Charging initiated, awaiting Cycle: rapid flashing: on for 200ms, then off for vehicle response 1000ms, twice; followed by a 3000ms off. Charging connector Cycle: rapid flashing: on for 200ms, then off for Green... -
Page 17: Troubleshooting
TROUBLESHOOTING Indicator color EV charger status Indicator status Relay adhesion Steady red Cycle: on for 500ms, then off for 500ms, once; Leakage current fault followed by 3s off. Cycle: on for 500ms, then off for 500ms, 2 times; CP fault followed by 3s off. -
Page 18: Routine Maintenance
ROUTINE MAINTENANCE Chargers do not need special maintenance. You are advised to check and clean the enclosure of the charger and accessories such as the charging connector every six months. Check whether the charger and cables are damaged. Use a dry cloth to clean the surface of the charger. Do not spray water directly on the charger. Do not use corrosive cleaners, glass cleaners, or organic solvents. - Page 19 PIN CODE...
- Page 20 Malmbergs Elektriska AB, PO Box 144, SE-692 23 Kumla, SWEDEN Phone: +46 19 58 77 00 info@malmbergs.com www.malmbergs.com...
Need help?
Do you have a question about the Evon Ztart and is the answer not in the manual?
Questions and answers