Advertisement
Quick Links
Y
Parts Included:
A
Work Surface Cubby
C
Fixed Stanchion
E
Adjustable Stanchion
Tools Required:
#2 Phillips Bit
Power Driver
Z
© 2012 Herman Miller, Inc. Zeeland, Michigan. Printed in the U.S.A.
Part no. 1BDHXW rev A.
Y, L, Canvas are among the trademarks of Herman Miller, Inc.
TM
Illustrations and specifications are based on the latest product information available at the time of publication.
The right is reserved to make changes in design and specifications at any time, without notice, and also to discontinue products.
Tu
Laminate Work Surface and Extended Cubby
™
Installation
Work Surface
D
Stanchion
1/8" Drill Bit
B
Extended Cubby
G
F
L Bracket (2)
1/4-20 x 3/4 Pan
J
Head Machine
Screw (2)
L
1/4-20 Hex Nut (2)
Hardware Pack
#10-12 x 3/4"Pan
Head Tapping
Screw (12)
K
1/4" Flat Washer (2)
1
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for HermanMiller Tu
Summary of Contents for HermanMiller Tu
- Page 1 Laminate Work Surface and Extended Cubby ™ Installation Parts Included: Work Surface Cubby Extended Cubby #10-12 x 3/4”Pan Work Surface Head Tapping Fixed Stanchion Stanchion Screw (12) L Bracket (2) 1/4-20 x 3/4 Pan 1/4” Flat Washer (2) Head Machine Screw (2) Adjustable Stanchion 1/4-20 Hex Nut (2)
- Page 2 1. Place Cubby bottom side up on clean padded surface. 2. Position Fixed Stanchion(C) onto Work Surface Cubby(A) or Extended Cubby(B). Align outside pilot holes in Cubby with outside holes in Stanchion. 3. Attach Stanchion to Cubby with 4 Pan Head Tapping Screws(G).
- Page 3 Pilot Holes 7. From under table, attach L-Brackets(F) to Stanchion with 2 Pan Head Machine Screws(J), Flat Washers(K) and Hex Nuts(L). 8. Using L-brackets as template, drill 4 pilot holes into table. CAUTION: Be sure not to drill through table top. 9.
Need help?
Do you have a question about the Tu and is the answer not in the manual?
Questions and answers