Sing The - Marmitek IP EYE ANYWHERE 241 - ADVANCED Installation Manual

4.4.5 Network >> Wireless >> WPS Setting
WPS (Wi-Fi Protected Setup) sets a new standard of Wi-Fi
security, providing a simplified secure network setup solution for
the end users. Once the required settings have been completed,
your wireless network can be protected by simply pressing the
WPS button on the camera.
z PROTECTED SETUP: Press the Reset to Unconfigured
button to reset the WPS configuration of the camera.
z WPS
- PIN Mode: The PIN (Personal Information Number) mode
builds the connection by entering the PIN Code directly.
Once you enter the PIN Code of the camera on the router
(or access point) that supports WPS, you can directly
build a WPS connection between the camera and the
device by simply pressing its WPS button.
- PBC Mode: The PBC (Push Button Configuration) mode
builds the connection by scanning the devices in the
wireless network. Once you press the camera's WPS
button, it starts to scan the WPS devices in the wireless
network, and then you can build the WPS connection by
clicking the Connect button.
z Device Status: Display the WPS configuration of the
camera.
TIP The Power LED indicates the WPS connection status by:
- blinking 3 times when the connection is built successfully.
- repeating 3 times of short-short-long blink when the
connection is failed.
40 ©
MARMITEK